Awesome!!! I really like the attention to detail - great upholstery job BTW, and the champers for Barbie! Of course the flying is quite impressive as well.
Hi there, ...not really. Only during ramp-up when starting the bird the vertikal fins go through a minor area of resonance. The main rotor speed is set to 1.280 rpm and there the fin (s) are calm.
Hello, how are you? In my Helicopter I made very close to your setup, however on the 3rd flight, the center of the gear that transmits to the tail broke, spinning free, can it be factory defect since it comes assembled in the kit? Would you have any opinion? Luckily I had very little breakdown on the heli due to being very low in flight. Thank you, my friend!
Hi, thank you for the tips and attention, my friend !!! I noticed you are using fan for ESC, could you inform me details so I do not do it wrong? You call him straight into the esc? Thank you one more time.
Hi Lincoln, the small ESC fan is a good proof for my safety paranoia 🤣 on warm days the ESC got quite a bit hot, therefore I installed this standard 5V fan facing right at the ESC. Now the ESC never gets warmer than 50 degrees C even after longer flights in summer 👍
Hi Lincoln, I am using the Kontronik 700-52 and the Castle Edge 120HV on 12s, 5.000mAh, works really nicely. Flight time is around 8 minutes with 20% reserve. However: The 700-45 would be an better fit as my Castle ESC runs at about 65% for a main rotor speed of 1.280rpm which appears to be very suitable for smooth scale flying. Hope this helps :-)
Awesome!!! I really like the attention to detail - great upholstery job BTW, and the champers for Barbie!
Of course the flying is quite impressive as well.
Magnifique!!! 👌👍
Very nice! I love the video from inside the helicopter!
I used a FlyCam Eco HD that is hidden underneath the arm rest
Toller Scaleausbau, Hut ab!
Where did you find a pilot figure to fit the Bel 429? I have the Bell 429 also and am finding it hard to find a pilot that fits.
do you also have vibrations on the vertical fins ? Thanks
Hi there, ...not really. Only during ramp-up when starting the bird the vertikal fins go through a minor area of resonance. The main rotor speed is set to 1.280 rpm and there the fin (s) are calm.
Hello, how are you? In my Helicopter I made very close to your setup, however on the 3rd flight, the center of the gear that transmits to the tail broke, spinning free, can it be factory defect since it comes assembled in the kit? Would you have any opinion? Luckily I had very little breakdown on the heli due to being very low in flight. Thank you, my friend!
Hi, thank you for the tips and attention, my friend !!! I noticed you are using fan for ESC, could you inform me details so I do not do it wrong? You call him straight into the esc? Thank you one more time.
Hi Lincoln, the small ESC fan is a good proof for my safety paranoia 🤣 on warm days the ESC got quite a bit hot, therefore I installed this standard 5V fan facing right at the ESC. Now the ESC never gets warmer than 50 degrees C even after longer flights in summer 👍
Hi, I'm putting together the same equipment, which engine and engine are you using? Thank you Lincoln
Hi Lincoln, I am using the Kontronik 700-52 and the Castle Edge 120HV on 12s, 5.000mAh, works really nicely. Flight time is around 8 minutes with 20% reserve.
However: The 700-45 would be an better fit as my Castle ESC runs at about 65% for a main rotor speed of 1.280rpm which appears to be very suitable for smooth scale flying.
Hope this helps :-)
Why not would you show us turn on lights for dusky before night. Come on video again