Why This Print Fail?
HTML-код
- Опубликовано: 11 сен 2024
- Why This Print Fail? #Layer shifting #Ladder effect #Reasons #Solution
Explanation on ladder effect, layer shifting for 3d printing failure.
Reasons and solutions to solver layer shifting
#3D print fail
#Layer shifting
#Ladder effect
I just want to say this video was excellent! I wish more support videos were as concise, well illustrated and thorough as this video! I feel this should have many more views than it does!
Very informative video, thank you for taking the time to film and upload it.
Very underrated video but has heaps of very useful info! Must watch for new comers
A mask I was making shifted a full 10mm and then finished printing flawlessly.
Belts are tight. It was a 26 hr print on Ender 3.
could this be caused by extra strain on the motors because of too-tight belts?
Thank you
Qma Galadriel channel just come back to visit your channel :)
Thanks for support
@@gravity-less3dprinting624 Welcome to come to visit my channel:)
I am having these issue just on the y axis, trying to solve it right now.
Good luck, my friend🙂👍
Try going into your firmware settings and lower your “y” axis speed. That is if you have checked belt tension and pulley already.
Did you solve it? I have the same problem.
@@jefferylittleton1005 I solved all of my issues. Ended up being the crap drivers on the 4.2.2 board. Upgrades to a 4.2.7 with branded German made driver chips and all issues are gone.
@@ericvail6528 this is what I was thinking considering it started all at once without any mechanical changes, and that small prints are usually okay. Thanks for the advice!
No sound Feb 23
Come back support👍👍