One possible way to remove this effect is to slightly change the step divider on the stepper motor driver. If you are not an advanced machine operator, then this may be a bit difficult. But if you are not afraid, you can make the backup of the vendor settings in RD works, change the step divider to the neighboring one when the driver is turned off (for example, if it was 5000, set 4000). Then the gear ratio will need to be changed in RD Works so that the size of the products matches the desired one Also, reducing the gas pressure has a positive effect on the quality of the acrylic edge. But you can't completely remove the gas - the focal lens may be damaged.
Hello! Our aplogize for long answer🙌 If you'll just change sensor - no need to adjust anything. This sensors is NPN, NO. If you'll assemble your own machine - just mark checkbox "use limit trigger" in vendor settings and check that the connection is correct.
Thanks bro
👍👍🔥🔥🔥👍
Sir I have cnc router machine ...same problem I am facing ..if I replace the sensor then might be issue that coordinate mistake for home position?
One possible way to remove this effect is to slightly change the step divider on the stepper motor driver. If you are not an advanced machine operator, then this may be a bit difficult. But if you are not afraid, you can make the backup of the vendor settings in RD works, change the step divider to the neighboring one when the driver is turned off (for example, if it was 5000, set 4000). Then the gear ratio will need to be changed in RD Works so that the size of the products matches the desired one
Also, reducing the gas pressure has a positive effect on the quality of the acrylic edge. But you can't completely remove the gas - the focal lens may be damaged.
After install sensor at the first time how to setting at ruida 6445g
Can you help me please
Thanks
And the sensor is npn or pnp sir
Hello! Our aplogize for long answer🙌
If you'll just change sensor - no need to adjust anything. This sensors is NPN, NO.
If you'll assemble your own machine - just mark checkbox "use limit trigger" in vendor settings and check that the connection is correct.
Sensor lights work but the head doesn't stop
Sensors problem
How set 4mm shet foks set ?
What do you mean “shet foks”? 👀