UBEC 3A ESC 5V Power Supply for Receiver - DIY

[@richardwagner9239]

Thanks for the video. Perhaps you can do a rehearsal before videoing

[@gregorydahl]

I like to bind reciever first before putting reciever and drone together . Elrs ans rsxr and frsky r9m last week took all night different wires different batteries different transmitters . And crossfire worked . Now i bought 3 more elrs recievers to try using just 5v .

[@negativentry]

Hello friend, I have CM703 and it doesn't say battery ... the 3 pin pairs are as follows: PPM, AUX2, AUX1, GEAR, RUDD, ELEV, AILE, THRO, and BIND at the bottom. There's no info on the internet how to power it directly from the battery or psu ... Any ideas ?

[@jonashediger182]

If I connect a 4s lipo to my 4s esc, how much voltage will be outputted go the reciever? My reciever only supports 3s so will it burn through? Thanks

[@ManicQuinn]

I need to know this too xD

[@hughragg7753]

A esc is put in a power line to reduce the amount of energy into something

[@easonliu600]

Does it require 5V? Or is 4V, 6V, ect. Acceptable

[@herminigildojakosalem8664]

Hello. The RX unit (S603) shown in your video, is it good? Is it reliable? Will you recommend it? Thanks.

[@jonashediger182]

Is the output from the esc to reciever always 5v?

[@hughragg7753]

Yes

[@T.3dwin]

This helped out alot, thank you

[@ourchannel8215]

BEC bro..hehe

[@muratsenatalay3078]

:) sen bu anlatımı bırak. Beceriksizce bir anlatım :)