BMW G8X M3/M4 EVENTURI CARBON INTAKE INSTALL!!! (DIY)

Hope you guys enjoyed this one! This intake looks so good in the engine bay, the carbon fiber is just killer!
Buy this intake here: www.eventuri.n...
Check out our M performance HAS kit install here: • BMW G8X M3/M4 M PERFOR...
Thank you so much for watching! IF YOU ENJOYED THIS VIDEO SMASH THAT LIKE BUTTON!
If you guys have any questions feel free to ask down below in the comment section! If we dont get back to you, its because youtube thinks its ok to not notify us when some of you comment, so please be patient we will get back to you!
Hit that Subscribe button for new videos, and to follow upcoming BMW shenanigans going on at NRP
FOLLOW OUR OTHER SOCIAL MEDIA FOR EARLY SCOOPS AND SPOILERS
► Instagram: @northraleighperformance
► Tiktok: @northraleighperformance
North Raleigh Performance
Location: 3101 Spring Forest Rd, Raleigh, NC 27616
Number: [phone]
For Quotes please email: [e-mail]

[@bretbloom834]

I lovvvvveeee when the hardest bolt to get off the vehicle isn’t shown at all they just skip over it like bro show me unscrewing the bolts so I can follow the same wacky tool set up required to get one of the hardest ones off. Been stuck for an hour. I hate tutorials they always do that.

[@aremmell]

You said in the video you'd list the torque specs for the strut brace bolts, but I didn't hear them, and don't see them in the description.
I found the specs on bimmerpost and they are as follows:
- Center point: 56Nm (41.3ft-lbs) + 90º
- Strut towers: 28Nm (20.65ft-lbs)
I have heard that you are not supposed to re-use the center point bolt, but I have not clarified that with my dealership yet. I will post again if they advise to not re-use it.

[@aremmell]

I can confirm that the BMW AIR document does say "renew screw" underneath the description for the center point bolt (M10x35).
You should probably be replacing that bolt every time you remove the strut brace.

[@ottobong]

looks like a lot of engine movement when revving...