if slab beam is at 4ft and if i wanted to extend room to 5ft, can i do that without slab beam? if 6 inches - 1ft deviation is acceptable? or is it better to use low weight bricks such as AAC/fly ash bricks?
Hi, thanks for letting us know. Could you please reach out to our Technical Support Team via globalsupport@protassoftware.com or the ticketing system on Prota Help Center? Once you reach out, we will answer and investigate this issue in detail immediately. :)
Dear Sir, in Protastructure 2022 V 6.0.431 trial version , the Edit Load tab is not working when you start adding wall loads.
Thanks
Experienced the same issue
Same issue experienced here 😢
if slab beam is at 4ft and if i wanted to extend room to 5ft, can i do that without slab beam? if 6 inches - 1ft deviation is acceptable? or is it better to use low weight bricks such as AAC/fly ash bricks?
The Beam load editor is not working. I add loads and simply as I press ok no loads are added!!!
Hi, thanks for letting us know. Could you please reach out to our Technical Support Team via globalsupport@protassoftware.com or the ticketing system on Prota Help Center? Once you reach out, we will answer and investigate this issue in detail immediately. :)