Extracting then replacing a broken off Zerk grease fitting

used an E-Z out reverse thread scew extractor to remove a zerk on my mower that was broken off flush with the surface of the wheel.

[@Samlol23_drrich]

It’s easier for me to use the pliers “backwards” when I don’t have to apply much pressure like you see in this video, so before anyone comments…..I know it’s backwards.

[@Samlol23_drrich]

Thanks. Amazingly just took the mower out of storage for the winter. Fuel pump is leaking and another zerk is gone. I’ll look into it. I’ve got tons of T15s, T20s and T25s. Every time I buy some deck screws I get another crummy bit.

[@carlosjoelgarcia3200]

I like the Thread Lock trick. Thank you for posting.

[@Samlol23_drrich]

Thanks for commenting!

[@bertschannel3795]

Thanks for the video

[@Samlol23_drrich]

……and thanks for taking the time to leave a comment.

[@andrewwhitelocke6041]

Can also sacrifice a torx bit !

[@javiercorreapr9977]

Thanks for sharing. Where you get the grease gun connector tip at 5:54 ?, I like it

[@Samlol23_drrich]

locknlube.com/pages/the-original-locknlube-grease-coupler
Thanks for commenting. These tips are great. They lock on every time.