HPC Trochoidal

[@outlaw867]

Mich würde die standzeit der Werkzeuge bei den schnittdaten interessieren...

[@HolzDennis]

Sieht schön böse aus. 4mm schnitt im Radius ist schon ne Menge, schöne Späne und eine gute Zeit beim zerspanen.

[@PrasadSonawanePrince]

The distributor for these types of endmills are available in India? Which type tool holder you are using for these type milling? And much time it will take to wear out its flutes? i.e. life of endmill with these type of milling?

[@fraisagroup]

Hello @ Prasad Sonawane.
Please contact [e-mail] and we can connect you with the responsible distributor.

[@洪素鶴-t2u]

分享到這裏面讚

[@themonkeyproject]

Is that a regular old side-lock holder? Why not something like a milling chuck for aggressive cuts like this?

[@fraisagroup]

Yes this is a weldon holder. We have had very good experiences with it for roughing operation.

[@洪素鶴-t2u]

分享，不怕比較😃😍🥰🙏

[@ipadize]

Das ist doch bestimmt mit Powermill programmiert worden oder?

[@fraisagroup]

Hallo @ Santosi. Dieses Bauteil wurde mit SolidCAM iMachining programmiert.

[@surjeetsharma33]

​@@fraisagroupi think solidcam is developed by powermill.

[@basti1255]

not much left for finishing on the ground :D sometimes the flex of mashine, endmill end holder can exceed 0.35mm with high speeds in roughing

[@hansong_official]

it looks so nice

[@Foxy_TheCapitalist]

He looks at it nicely, but nothing more can be economically machined like this. It's a promo video. Not not like that.

[@JaakkoF]

Getting roughed workpiece in just a few minutes is exactly how it should be done. Everything else is just wasting time.

[@洪素鶴-t2u]

朋友有先傳個位老闆才知道，什麼機械銑床讚感恩阿們

[@ddmmxx89]

Looks nice, sounds bad! :D