I just bought this go kart brand new for my son and for some reason the front brakes do not lock up the front wheels. The brakes only lock up the rear wheels. I tried to bleed from each caliper and still no luck. Do you have any knowledge or tips?
When your bleeding the front calipers, did they bleed properly? Are they squeezing the brake disk properly?The calipers seemed the same on all four wheels on one I worked on.
@ no the front brakes barley had any fluid coming out. The back ones are fine right from factory. It was odd barely any fluid came out. And we pumped and pumped the brake pedal. The brake pedal alone barely moves. Maybe a quarter inch to half an inch if lucky
Sounds like something is wrong on your master cylinder where fluid should be pushed to front wheels. Are the fittings fully open when you unscrew the front brake lines from master cylinder?
@ I did not unscrew anything from the master cylinder I left it stock from factory. I only unscrewed the nut attached to the caliper and tried pushing the brake pedal for the fluid to push out of the caliper on each side
@@bluegrasskidthe engine and drivetrain components are what I would rate "good^, the chassis and rest of it are merely what I would say "should be better".
![Blox Fruits Dragon Rework Update [Full Stream]](http://i.ytimg.com/vi/EqDAp8udhm0/mqdefault.jpg)
Thanks for posting!
You're welcome
I just bought this go kart brand new for my son and for some reason the front brakes do not lock up the front wheels. The brakes only lock up the rear wheels. I tried to bleed from each caliper and still no luck. Do you have any knowledge or tips?
When your bleeding the front calipers, did they bleed properly? Are they squeezing the brake disk properly?The calipers seemed the same on all four wheels on one I worked on.
@ no the front brakes barley had any fluid coming out. The back ones are fine right from factory. It was odd barely any fluid came out. And we pumped and pumped the brake pedal. The brake pedal alone barely moves. Maybe a quarter inch to half an inch if lucky
Sounds like something is wrong on your master cylinder where fluid should be pushed to front wheels. Are the fittings fully open when you unscrew the front brake lines from master cylinder?
@ I did not unscrew anything from the master cylinder I left it stock from factory. I only unscrewed the nut attached to the caliper and tried pushing the brake pedal for the fluid to push out of the caliper on each side
Whats fluid level like in master cylinder? Maybe it's low on fluid.
Did your come with a low and high gear because I do not know how to switch it out of low gear
On this model there is only a LO range. No Hi. The shift selector is LO -N-RE
Thank you
My gocart is stuck in low gear also. I wasn’t even aware this gocart had a low gear. It won’t go into “D” instead it says “L” now.
This model only has L gear. L - N - R
What battery do you use?? I have been searching forever
amzn.to/3Zg5DO6 Is what I used.
I have the same go-kart I'm having problems with my won't start
Start with the basics; like put a trickle charger on the battery, do any indicator lights come on on dash, etc.
How much is it
Around 1200.
Is it a 2 seater ??
Yes it is. Even has seat belts for both driver and passenger.
@@crankytuber thanks sir, but is it big enough for a 14 and 15 year old there under 6 foot and under 200 pounds
I think with two riders 14 to 16yrs old you'd be somewhat cramped on there.
@@crankytuber how’s the quality of the engine and rest of the unit?
@@bluegrasskidthe engine and drivetrain components are what I would rate "good^, the chassis and rest of it are merely what I would say "should be better".