This is one of the best instructional videos that I have ever seen. Everything is explained very well and important points are emphasized and repeated. I can't say enough good things about this video and its presenter. Job well done!!!!!!!
Thank you so much for this video! My entire assembly came out and I was sewing by pushing it back in every few stitches! And all it took was looking for where the Lock Screen was and tightening it!!! I am in business again. Thanks!
@Ben you may have to damage it to get it out (new assembly not expensive so be prepared to get that ordered) There is a little hole where the spring comes out. Use that and put a screw driver against there to hit it (clockwise /counterclockwise) to get it to turn and loosen up. With the wd40 in there already it should break up easier once you're able to get it to turn a little bit. PERSISTENCE/PATIENCE IS KEY! Good luck!
This is one of the best instructional videos that I have ever seen. Everything is explained very well and important points are emphasized and repeated. I can't say enough good things about this video and its presenter. Job well done!!!!!!!
Again I Thank you for sharing your knowledge and experience.. Lately I am worshiping your knowledge !
Thank you so much for this video! My entire assembly came out and I was sewing by pushing it back in every few stitches! And all it took was looking for where the Lock Screen was and tightening it!!! I am in business again. Thanks!
Thank you for this very helpful video.
Great presentation and well explained from the professional. Thanks
just bought and rebuilt a typical gc0303 and this was the final piece of the puzzle getting it all back together. thanks great video
Very detailed. Needed the angle of the take up spring.
Thanks for this 👌
Very well-explained. Thank you so much.👍
Thank you
Thank you so much!!!
Bro,thanks
Gat that problem fix...🙏👍
Thanks so much 🙏 Sir . Very useful this video 🙏
Hi
Can u do video on how to set the foot max hi for Adler 269
What is the best sewing machine?
Fantastic.. Top man
Thanks a lot
Thx
Thanq thanq....
i cant get the last peice out. the peice that holds the spring
Some units have silicone to hold it in or it's just sticky or gunky. Night have to use some needle nose pliers and/or wd-40 to break up the build up.
@@josephpark2256 used wd40 and two needle nose pliars and still no luck. any other ideas? Thanks for the help
@Ben you may have to damage it to get it out (new assembly not expensive so be prepared to get that ordered)
There is a little hole where the spring comes out. Use that and put a screw driver against there to hit it (clockwise /counterclockwise) to get it to turn and loosen up. With the wd40 in there already it should break up easier once you're able to get it to turn a little bit.
PERSISTENCE/PATIENCE IS KEY! Good luck!
@@josephpark2256 I heated it up with a blow dryer and got it out!. Thank you