Lenovo Legion Go Controller Connector from Legion Go Community - 3D Printing

This video is about Lenovo Legion Go Controller Connector from Legion Go Community - 3D Printing
Files: gaming.lenovo....
Printing time: 8 hours and 49 minutes (from Cura Slicer)
Material: 35g (11.77m) PLA+, Yellow
Slicer: Cura
Infill: 15%
Layer Height: 0.1mm
Printing temperature: 208 C
Build plate temperature: 60 C
Retraction distance: 7 mm
Support: off
raft: off
Music: Don't Fret - Quincas Moreira.mp3 (from youtube audio library)
#3dprinting
#legion
#legiongo
#thingiverse
#ender

[@Salimji26]

I did not know there was a print in place version of this, I found the print files after I ordered this off aliexpress

[@Waterlemon369]

it saves time for printing, 😀

[@DabstiX]

ill take one in black ^^, should make a pistol housing for the controls like what the switch users get, ive been looking all over, with the gyro aiming a pistol would be legit lol

[@Waterlemon369]

It is a good idea. 😀 Not sure if the legion go controller supports the gyro controlling the mouse pointer. 😀

[@DabstiX]

@@Waterlemon369 It does

[@MobileDecay]

Does this open up and lock at specific angles or something?

[@Waterlemon369]

I think it should be able to open up from the design. However, I cannot open it up because of the filament fusion during printing. 😊

[@MobileDecay]

@@Waterlemon369 Ah! I hate that. 😂