Universal 433mhz Switch Copying Garage Opener Cloning Remote Control Key
HTML-код
- Опубликовано: 21 окт 2024
- Wireless remote control duplicator, duplicate your existing remote controllers for cars, car sunroofs, garage doors, gate doors, heating Systems, home automation e.g. lighting and etc.
High accuracy of copying and high effective of copying, easy to install and use.
Ultra-small error of copying data code and copy oscillation resistance. Privacy is strong.
Products link:bit.ly/2ODbskA
I love how they put out videos this fast and don't explain how the fuck to put the universal remote into learning mode!
did this work?
How to clear existing code, with same as black remote?
Will they work on 868mhz hormon
Hi…mine works when I copy the code but then after a few minutes it doesn’t work anymore…it’s like it loses memory????
I am unable to clear the code, any help please
What about if I just like to replace one of then? What should I press?
How can I make master remote for working all type of remote
Hello Sir: What exactly is the name of the decoder? Thanks.
It’s just a frequency counter
I found it as "QIACHIP Multifunctional RF Remote Control Signal Decoder RX480E TX118SA RX480E Tester 1527 2262 HCS HT Rolling code Tester"
i lost the old remote how to clone thanks
What if the original remote is low in battery and batt can no longer be replaced?
You bought a bad remote then
Hi, is this an Arduino project, ca you share it?
I finally found the product in the video its called "QIACHIP Multifunctional RF Remote Control Signal Decoder RX480E TX118SA RX480E Tester 1527 2262 HCS HT Rolling code Tester"
where do you buy?
i have if need
My old fob has two buttons. The right hand one operated the door. It cloned easily on button (B) on the new remote. It didn't clear either holding down (A) & (B) only flashed on (A). I just put remotes side by side and held down the right-hand button on my old remote and button (B) on the new one for a couple of seonds. (B) then showed a flickering blue light, new remote works OK. (A) button shows blue light but does nothing.
My old fob has two buttons. The right hand one operated the door. It cloned easily on button (B) on the new remote. It didn't clear either holding down (A) & (B) only flashed on (A). I just put remotes side by side and held down the right-hand button on my old remote and button (B) on the new one for a couple of seonds. (B) then showed a flickering blue light, new remote works OK. (A) button shows blue light but does nothing.
Hi everyone,
I would like to be able to receive the signal from a controller with an HCS301 (MICROCHIP KeeLoq) in the transmitter and with a PICxxx or an ATMELxxx in the receiver.
There is a library for ARDUINO about receiving the signal from an HCS301 and another to emit the signal from an HCS301, but I can't find it... I'm still looking.
Greetings to all.
How the Hell do these video makers always choose the most annoying loud background music known to Man.
You don't need background music for a tech video, it's not a Hollywood horror movie and you need the music to make people jump.