How to switch the output of the R-XSR from S.BUS signal to CPPM

Happy New Year! This video will show you how to switch the output of the R-XSR from S.BUS signal to CPPM. We hope you find this video helpful, thanks for watching!
FrSky R-XSR receiver
www.frsky-rc.c...
Purchase here
www.frsky-rc.c...

[@FpvTv]

it Does NOT work on newest access frimware, all my r-xsr receivers are upgraded to newest access firmware and I can NOT turn on SBUS

[@ManelPessanha]

how do you resolve?

[@mateuszkobuszewski2350]

I have same problem!

[@ManelPessanha]

Mateusz a have a solution

[@mateuszkobuszewski2350]

So i realized sbus output is connected incorrectly, before I had xsr and it has sbus on 5th and r-xsr on 4th pin. Now its working fine.

[@aker_fry]

On a side note, you might want to warn people watching this video that you've wired the wrong cables in your video example. Yellow cable here is Smartport for telemetry, but you're missing SBUS_OUT/CPPM wire. Just saying if any noob like me struggles in the future because they look at your wiring on here, replicate it and realize it doesn't work.

[@Derederi]

I might have just found myself. any advice on the correct wiring though?

[@siddharth4662]

how can we connect 6 digital servo to the single CPPM wire?

[@aker_fry]

Good to know. I don't get any signal on betaflight from my remote controller even if the binding is done so it's good to see that if I'm on SBUS_OUT I should see the blue light, I only have a green light at the moment. Although, is your RX on this video bind with your RC already?

[@sapata1871]

I fired up my Radio / quad and just hold the bind button down on the rx for a few seconds. Ta-Da! Blue led*

[@sapata1871]

Turned from solid gen to blue . And Armed!

[@rutledgeking7652]

I never get a blue light after holding button down for 4 seconds

[@Myllendorf]

The blue light on my reciever isnt on when I hold the button when powering on the reciever, any suggestions?

[@maxime_bht]

I need help, it's not working with my r-xsr..

[@AlmazWorks]

Hi there! Why I see solid light of all of LEDs (blue, red, green) when I turn to binding mode?

[@lowspecbenchmarks7983]

hello what transmitter can i use with this ??

[@brandonshepherd3317]

What if this doesnt work? I've pushed and held for over 10 seconds. No blue led

[@ManelPessanha]

do you have a solution?

[@sunsetpark_fpv]

@@ManelPessanha Yes. Hit it with a hammer approximately 17 times. Throw all the pieces in the trash bin. That's how I fixed mine....

[@maxime_bht]

same problem

[@lg8386]

I've access and don't turn on sbus, the receiver got to ppm (I think I've pressed a few of seconds the bind button for error)
Now don't switch to sbus

[@maxime_bht]

same problem

[@alexandrep2624]

@@maxime_bht it does not work with the access firmware. you got to be on accst firmware. I have 2 of them converted that way on old apm2 boards

[@Teramann]

Really! Super Useful