Genial. Hätte da noch paar Fragen. Welches Hotend verwendest du? Normales V6 kommt dieses mit dem Schmelzen da noch nach? Ist deine Teileliste fürn Ender5 oder PLUS?
Is fürn normalen Ender, ja, das V6 is i.o brauchst halt ne 24v 50w cartridge und ich schmiere den ganzen Block mit hitzebeständigem Silikon zur Isolierung ein, aber grundsätzlich ist das voellig ausreichend bin 0.2 Layerhöhe.
No and im unsure if im gonna release the needed files for it, there are many other linear rail mods for the ender 5 available, some of them might offer similar performance.
I just realized there isnt a pic of the printer, ill add some more in the description ! ( basically i just replaced the roller things with linear rails and added a bmg + pancake )
very impressive!! I am also running Klipper on ender 5 with direct drive (BMG + speeddrive mod from thingiverse). However, whenever I try acceleration above 1000mm/s^2, the printer is shaking like hell due to the mass acceleration, of the hotend, as well as the print bed following the shaking. How do you solve the shaking issue? Did you add additional weight to the printer? Or did you tight/glue/fix the printer to something else like a table/wall?
Hi, very impressive... I have the same config but when I try to push to hard I have layer shift??? Is it possible to have your printer.config to compare with mine please?
Super awesome! I’ve been looking for mod like this!
Damn specially for direct drive it’s very impressive. Mine rings hilariously at 5000 accel and 300mm/s
Genial. Hätte da noch paar Fragen. Welches Hotend verwendest du? Normales V6 kommt dieses mit dem Schmelzen da noch nach? Ist deine Teileliste fürn Ender5 oder PLUS?
Is fürn normalen Ender, ja, das V6 is i.o brauchst halt ne 24v 50w cartridge und ich schmiere den ganzen Block mit hitzebeständigem Silikon zur Isolierung ein, aber grundsätzlich ist das voellig ausreichend bin 0.2 Layerhöhe.
This is pretty amazing. Do you have a guide on doing this?
No and im unsure if im gonna release the needed files for it, there are many other linear rail mods for the ender 5 available, some of them might offer similar performance.
@@lenne-0815 i want to do this on an Ender 5 Plus
@@notabackupaccount7664 I would just be happy for a Klipper Config for a Creality V2.2 silent board...
very impressive, what mechanical tweaks did you do?
I just realized there isnt a pic of the printer, ill add some more in the description ! ( basically i just replaced the roller things with linear rails and added a bmg + pancake )
very impressive!! I am also running Klipper on ender 5 with direct drive (BMG + speeddrive mod from thingiverse). However, whenever I try acceleration above 1000mm/s^2, the printer is shaking like hell due to the mass acceleration, of the hotend, as well as the print bed following the shaking. How do you solve the shaking issue? Did you add additional weight to the printer? Or did you tight/glue/fix the printer to something else like a table/wall?
No i didnt, my gantry is much lighter than the standard gantry.
Hi, very impressive... I have the same config but when I try to push to hard I have layer shift??? Is it possible to have your printer.config to compare with mine please?