Can you configure all of these settings through standard zwave parameters? Looking to wire up some load cells for measuring the weight of propane tanks and wondering if I could use this with a 0-10V load cell amplifier with a non-Fibaro controller.
Thanks for this... very helpful... I am using SI with my HikVision Alarm Output so it notifies me if a line is crossed... only thing I can't get to show up on my Smart Implant is, if I leave the settings for Input Configuration to Not Used then, then, when I join the Yellow and Blue cable, I get the alert... if I change the Input Config to Binary Input and Motion Sensor, I don't get the alert coming thru.. do I need to change something else??
HI, sorry for late reply didnt get the alert - the config needs to be changed to Binary Input NC - so when line breaks occur it send the alert out to you.
@@YorkshireAutomation strange.. thats exactly what I had it set to.. and the alert was not picked up.. ironically, not setting it, I get the alert.. how strange...
Yorkshire Automation yep.. this is what I find little concerning about Fibaro... it works mostly... just not 100%.... still, better then most of what is on the market in the price range. Have a good weekend...
Can you configure all of these settings through standard zwave parameters? Looking to wire up some load cells for measuring the weight of propane tanks and wondering if I could use this with a 0-10V load cell amplifier with a non-Fibaro controller.
hi, you need a controller to configure all the parameters before you can setup to use a 0-10v load cell.
Thanks for this... very helpful... I am using SI with my HikVision Alarm Output so it notifies me if a line is crossed... only thing I can't get to show up on my Smart Implant is, if I leave the settings for Input Configuration to Not Used then, then, when I join the Yellow and Blue cable, I get the alert... if I change the Input Config to Binary Input and Motion Sensor, I don't get the alert coming thru.. do I need to change something else??
HI, sorry for late reply didnt get the alert - the config needs to be changed to Binary Input NC - so when line breaks occur it send the alert out to you.
@@YorkshireAutomation strange.. thats exactly what I had it set to.. and the alert was not picked up.. ironically, not setting it, I get the alert.. how strange...
@@rexgold101 strange but at least it's working!
Yorkshire Automation yep.. this is what I find little concerning about Fibaro... it works mostly... just not 100%.... still, better then most of what is on the market in the price range. Have a good weekend...
How can I make it so, the ordinary toggle switch I have in my garage, only need 1 click, instead of a 3 click to react?
what do you mean?
@@YorkshireAutomation to get my normal switch on the wall to react with the smart implant, iv gotta click it 3 times to activate my garage opener
@@thomassrnes1845 send me email with diagram of how you have connected it and what parameter you have set.
Send to info@yorkshireautomation.co.uk