I just got this sight and can’t wait to shoot it this weekend however I am very confused. I have the 5 pin version. So if I loosen the 4 screws at the dead stop position and move the sight housing up so my 60 pin shoots 30 and make my mark. Then roll down until my 60 pin is hitting at 60. Will that not mean that my 20 pin will be too low at the dead stop position? Or will I have to move my sight housing again and re dial my 20 pin? Im sorry I hope this question makes sense. Hopefully I am just overthinking it but I am very confused lol. Thanks!
Where do you buy new indicator yardage needles? I went to swap and stepped on one I needed and bent it up.
Please contact the warranty dept. and they will get you set up!!
I just got this sight and can’t wait to shoot it this weekend however I am very confused. I have the 5 pin version. So if I loosen the 4 screws at the dead stop position and move the sight housing up so my 60 pin shoots 30 and make my mark. Then roll down until my 60 pin is hitting at 60. Will that not mean that my 20 pin will be too low at the dead stop position? Or will I have to move my sight housing again and re dial my 20 pin? Im sorry I hope this question makes sense. Hopefully I am just overthinking it but I am very confused lol. Thanks!