Sweep defined by outside curves | Creo Tutorial

[@alexespinoza2153]

Awesome, thanks for this tutorial, 3 days and finally see the light.

[@alexespinoza2153]

Awesome, thank you very much for this tutorial, finally after 3 days I can see the light.

[@nafeesrehman5094]

4K SIDE IS LEARNING

[@zujazakon]

you are the best you help me alot

[@surendranachan6644]

Thanks

[@meharsamba]

So basically, if yiu lock the dimensions in sketcher mode. The system will follow them through even in sweep mode. ?? Is that it ?? All you need to do is lock the dimensions ?

[@4kside]

No, you do not need to lock dimensions (in reality, I know that is possible but I never use Lock dimensions 😉👌

[@meharsamba]

@@4kside then what did you do different? That was the only thing i observed...