Theres supposed to be a slight gap between moving blade and Stationary blade. Zero gap just means to get moving blade as close to non moving blade as possible . Fully zero gapped just causes cuts
Maybe you reduced the adjuster too much bro. In my video I said that it is important not to reduce too much to avoid offset of the blades. That's the reason that it's not cutting.
@@JunbaTeks i didn't smooth it yet i just did that stretching own with a screw ....when i fixed it back the rotor doesn't vibrate and if it vibrate the blade won't cut .....i wish i can show you🥺
Bakit gumagamit ng papel de liha kapag ito ay gumagana nang may pagbabago lamang sa screwdriver? Please pwede mo bang ipaliwanag? Ano ang makukuha ko diyan? Sana maintindihan mo ang tanong, dahil gumagamit ako ng google translate para dito :)
Theres supposed to be a slight gap between moving blade and Stationary blade. Zero gap just means to get moving blade as close to non moving blade as possible . Fully zero gapped just causes cuts
it’s a vintage t9 it’ll be fine
Zero gap gaw kaya kaayo bisan pa piyongan 🤩
Salamat sa bidyong ito idol.
El vídeo que busque por todo habla hispana. Y tú lo tenias gracias.
Gracias tambien hermano.
Salamat at ipinakita mo sa akin ang gusto kong gawin
Wow thanks a lot. It worked!
You're welcome!
Helped a lot
Thanks bro
Thanks.
You're welcome 💖
Salamat sa video boss . Ganyan din gagawin ko ds hiena na trimmer ko di kasi naka zero gap
Gumana boss
Balak ko den kasi gawin sa hiena ko
Kamusta lods.ganda naman nya.
Salamat idol.
4:43
Does this work with the digital t9 clippers as well
Yes sir.
BOSS gana ba to
Sir i buy t9 trimmer but my trimmee don't cut my hair after i regmark but not work why can u tell me...
Please follow this steps. Thanks. ruclips.net/video/luZZzZKiYjo/видео.htmlsi=ycz6oyNeqz3jY7o7
Please i need an urgent answer ..... My own i have tried the whole tutorial and it's not cutting😢😢
Same here too
Maybe you reduced the adjuster too much bro. In my video I said that it is important not to reduce too much to avoid offset of the blades. That's the reason that it's not cutting.
@@JunbaTeks i didn't smooth it yet i just did that stretching own with a screw ....when i fixed it back the rotor doesn't vibrate and if it vibrate the blade won't cut .....i wish i can show you🥺
Make a video bro and send it to my messenger. Junior Bakang
Is it a rough sandpaper
Yes
@@JunbaTeks thanks
@@JunbaTeks I am going to try it hope it works
Just sanding slowly to avoid overdoing the deduction.
@@JunbaTeks ok sir
Okay padin ba trimmer mo ngayon.
Yes bossing very ok.
Bakit gumagamit ng papel de liha kapag ito ay gumagana nang may pagbabago lamang sa screwdriver? Please pwede mo bang ipaliwanag? Ano ang makukuha ko diyan?
Sana maintindihan mo ang tanong, dahil gumagamit ako ng google translate para dito :)
Iba iba kasi ang design sa trimmer sir. Itong sa vintage t9 ay walang adjustment gamit ang screw, kaya ito lang ang paraan para ma zero gap natin ito.
@@JunbaTeks Malinaw. Maraming salamat sir, natulungan nyo po ako, good luck
@@lukadabovic6470 Maraming salamat din sa iyo sir.