Homemade F1C100s Development Board

The processor boots from a micro SD card that has a bootable linux image.
If there is no SD card in the SD card slot, the processor boots into USB Fel mode.
Currently, Im able to UART into the device and navigate the file system.
Future plans are to have the processor output a composite video signal.

[@dellmyer]

Excellent job!

[@ismailakbulut2793]

nice job 👏

[@ukrand9204]

Nic3

[@clubpasser123454321]

Where did you get the information on how to boot it up? I’d like to make something using this chip also. Nice job btw.

[@theengineer9910]

I got lucky with finding Information on reddit about how the F1C100s boots up. I got even luckier when I found "licheepi-nano-mainline" by goediy on github. With his repository I was able to make a bootable SD Card. The image is targeted towards the Li Chee nano dev board but hopefully I can modify the image to add drivers. If not then ill just play with embedded linux on my Zynq 7000.