Please do not misunderstand me but the bike that you had has got a regulator rectifier unit in it which will constantly charge the battery at 14.5 V on numerous amps I may be misunderstanding you but the battery charging and discharging of 18 650s need very precise charging And discharging are you saying that the bike has this sort of battery management system and not a regulator rectifier unit I do enjoy your videos and I find them very informative a big hi from the UK thank you for your content
Charging the lithium batteries without BMS is not a good idea..! The batteries will be dead or exploded soon... You have to use BMS (Battery Management System)..!
Use lead rosin core 60/40 solder, forget the lead free stuff it's garbage, clean the surfaces with fine sand paper before soldering, use a proper sized soldering iron about 40 watts for this job, solder quickly using no more heat than needed - do not over heat. With leaded solder the finished joint should look shiny, if not, reheat and add a little more solder. And again, don't use lead free solder, it's too hard to solder with, especially for a beginner.
@ABTabi bhai me bhi 12 volt lithium battery banya he par Scotty start to ho rhi he par Scotty chalte chalte battery discharge ho jati he 12 volt se 9 voltage ho jaati he Horan nhi bajta na hi Scotty satat hoti he bms bhi lag rakha he 12 volt 20 amh kya kare bhai
Explanation is not good bro. You need to tell in detail bro by putting on the paper how to connect. You just did for your self bro. Sorry to say next time to do better
@@ABTabi eh no. cant because the bms need to check the + - pole to balance. you made a 4s unbalanced system . so your video shows a 4S system with 16,4V , unbalanced. Dont make this setup.
He's so insistent that every vehicle.... Including a friggin motorbike that only shas a simple 2 or 3 wire rectifier to go from 14ish volts AC to DC. That's it. He's wrong in saying every vehicle has a bms. Actually ZERO vehicles especially bikes have bms, as in they DO NOT HAVE IT
И каким током от генератора оно начнет качать заряд?? А когда оно на скорости взорвется между ног?? ЗАЧЕМ ТАКОЕ ПОКАЗЫВАТЬ? ОЧЕНЬ ПЛОХОЕ ОТНОШЕНИЕ к каналу появилось.
No need extra BMS,,,,,,, dear friend's ,,,,,, every vehicle there use battery ,,,,,, have a Battery Management System ,,,,,,,
LOL. Let me know how to locate the BMS in bike and how two wires can balance 3 cells equally and individually.
Where is BMS in two wheeler or Four wheeler ???
One time this battery will get discharged and throw it
@@basaksudipto92 brow please tell me where is bms in acid battery
Please do not misunderstand me but the bike that you had has got a regulator rectifier unit in it which will constantly charge the battery at 14.5 V on numerous amps I may be misunderstanding you but the battery charging and discharging of 18 650s need very precise charging And discharging are you saying that the bike has this sort of battery management system and not a regulator rectifier unit I do enjoy your videos and I find them very informative a big hi from the UK thank you for your content
According to him, Rectifier = BMS
Bro. Please btana Abhi tak koi problem ayi bina BMS KE ?
Superbra! Allt väl gjort,och tydligt.
Good battery
But hare is a problem because you don't use any type of BMS so this battery will over charge and it will dead after some time
Dear friend every bike have BMS ,,,,,,,,,
@@ABTabi e mesmo ?🤖
Are you using all the batteries are the same mAh?
Friends it is totally fraud. without BMS can't manage when battery charging gose full.
Good job! Now the battery is lifetime and nowadays, BMS is standard installed in every motorcycle, don't worry.
Thanks for visit ,,,,,,,,,,,,
Charging the lithium batteries without BMS is not a good idea..! The batteries will be dead or exploded soon... You have to use BMS (Battery Management System)..!
My dear friend every bike have a BMS ,,,,,, if your bike have no,,,,,,, you must use controller
Bhai bike ma kuch problem to nhai hoge na
Does the job excellent. !
Hi, thank you for this 9idea!!! also im
new at soldering,, what kind are you using in this video?
Use lead rosin core 60/40 solder, forget the lead free stuff it's garbage, clean the surfaces with fine sand paper before soldering, use a proper sized soldering iron about 40 watts for this job, solder quickly using no more heat than needed - do not over heat. With leaded solder the finished joint should look shiny, if not, reheat and add a little more solder. And again, don't use lead free solder, it's too hard to solder with, especially for a beginner.
Pomysłowe ale wykonanie godne partacza
How to stop over charging the battery.what is the output
Hadir nonton, conten nya luar biasa👍👍👍👍👍👍
👍👍👍👍👍👍
@ABTabi bhai me bhi 12 volt lithium battery banya he par Scotty start to ho rhi he par Scotty chalte chalte battery discharge ho jati he 12 volt se 9 voltage ho jaati he Horan nhi bajta na hi Scotty satat hoti he bms bhi lag rakha he 12 volt 20 amh kya kare bhai
ye nahi hoga, esko bad de kar ap sourum se newa bettary kin li jiya.
manye vi bohut try kiya but nahi huya😅
BMS is needed other wise it will destroy your own rectifier and short circuit or you will replace with LifeO4 battery. Other wise it is ok.
Bruh, just wait his motorcycle to blow up because of the battery overcharged
🤣🤣🤣
What about ampere and capacity?
BMS should be attached
Last m power check karke kyu nhi batayi
Explanation is not good bro. You need to tell in detail bro by putting on the paper how to connect. You just did for your self bro. Sorry to say next time to do better
From ingenious 101
Bhai bms to lagao warna balst ho jaayega 😮
Where is bms?
You build battery without bms why
Ele falou que não precisa de BMS que a moto já tem 🤖
No need extra BMS,,,,,,, dear friend ,,,,,, every vehicle there use battery ,,,,,, have a Battery Management System ,,,,,,,
@@ABTabi eh no. cant because the bms need to check the + - pole to balance. you made a 4s unbalanced system . so your video shows a 4S system with 16,4V , unbalanced.
Dont make this setup.
it's not 12 v battery its 16 v battery coz he is using 4 cells * 4 cells even he did not check output voltage
O bom é consertar já as bateria de chumbo e treta
good
Thanks ,,,,,,
must use 3S BMS module
Dear friend,,,,,, every vehicle there use battery ,,,,,, have a Battery Management System ,,,,,,
He's so insistent that every vehicle.... Including a friggin motorbike that only shas a simple 2 or 3 wire rectifier to go from 14ish volts AC to DC. That's it. He's wrong in saying every vehicle has a bms. Actually ZERO vehicles especially bikes have bms, as in they DO NOT HAVE IT
Thats not to say that it won't work but it will fail prematurely and that is an absolute fact
Its going to burn up with out BMI
Thanks bro
Welcome
И каким током от генератора оно начнет качать заряд?? А когда оно на скорости взорвется между ног?? ЗАЧЕМ ТАКОЕ ПОКАЗЫВАТЬ?
ОЧЕНЬ ПЛОХОЕ ОТНОШЕНИЕ к каналу появилось.
😂😂😜
Must use BMS..OK
No need extra,,,,,,,, Dear friend every bike have BMS ,,,, OK ,,,,,,, make and enjoy,
Nice
Thanks
waste of 18650
B m s unit
👎
Bhai bms to lagao warna balst ho jaayega 😮
mary pyary doost her motorcycle ke andar BMS hota hy ,,,,,,,
Nice
Thanks
Nice