⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: ruclips.net/channel/UCJ9xpq0qUZevSEdBSFqO2ow ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
@Grady How did you go with it? I want to open the door panel on Ford Focus 2012 for rattle noise and to put anti rattle tap to eliminate those annoying noise.
You should have watched a video on how to remove that panel, or looked it up in a diagram, before trying. You forgot to remove the red reflector and the screw behind it. You broke that part.
15+ are bit different. There are two 7mm hex head bolts on the bottom of the front two doors as well as an additional Torx 25 bolt underneath the reflectors (which slide out toward the rear of the door).
Thanks for the vid! Using the wrong panel tools. Should get the squeeze handle kind that way it wont gouge the bottom of the door panel when prying. Pick tools work good for removing the cap behind the door pull without damaging it.
I’m here to help. Those clips your popping off, just please stop doing that. Majority of not all panels are built to twist or slide up, especially in 2011 up cars due to Alldata- Pause I’m at 7:02 of your video and I had to pause it, this right here you done damage. Always Slide up PANELS. Always remember : Door panels go up or twist-up Arm panels go rear wards Kick panels will click but always slide rearward Convenience tray(cup holders trans shifter area) slides rearward Dash gos up fwd
I just pulled apart and reinstalled the panels on my ‘06 Harley Davidson F150 without damaging or losing a single clip, those Focus panels look and sound very tight…
PLEASE HELP ME!!! Thank you for all your videos they have helped a lot however I am stuck on how to install passanger glass on my 2012 ford focus... Is there a treat to reconnecting glass to the plastic clips that I believe are part of the window regulator
Great vid, thanks! My door got over extended and now the lower hinge bent outwards a bit, causing there to be no gap between the door and the front fender - the stick trick doesn’t work with the focus because of the way the hinge is made… any ideas?
Do all Ford Focus have the electric window problems? I have a 2005 and either the driver's window does not go down consistently or the passenger side doesn't go up consistently or jams half up or half down. Can you suggest a car with no electric window problems? It is costly to get them fixed. A new motor was put in and then I was told it must be the electrical system 😔
Are you please able to show me how to raise my driver side window? It's stuck down in the door, the switch is broken (I think) and it's freezing cold, I have a cardboard window now for 4 days. Just need to get that window back up out from inside the door and pull back up to closed position. Thank you
DAMN it's a whole lot more complicated with electric door and Windows n shit. What happened tothe days when you just took out a few screws and pried the panel off and worked around the minor hardware. And the only tools you need were a Phillips head and a flat head😟 Lol
You sir are a hack. I almost broke multiple parts following along with your video. Why would you make a video on how to do something when from the start you had absolutely no clue what you were doing. If that was my car you were working on, I would have been mortified to watch that.
⛐ Check out our Garage to see what tools we use and recommend:
www.amazon.com/shop/worldmechanics
⛐ Subscribe and hit the notification bell by the subscribe button for new videos: ruclips.net/channel/UCJ9xpq0qUZevSEdBSFqO2ow
⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
Ford does not want that panel to come off! Thanks for explaining so well. I'm doing this today.
@Grady
How did you go with it?
I want to open the door panel on Ford Focus 2012 for rattle noise and to put anti rattle tap to eliminate those annoying noise.
You should have watched a video on how to remove that panel, or looked it up in a diagram, before trying. You forgot to remove the red reflector and the screw behind it. You broke that part.
Thank you for saying that you helped me out
15+ are bit different. There are two 7mm hex head bolts on the bottom of the front two doors as well as an additional Torx 25 bolt underneath the reflectors (which slide out toward the rear of the door).
Thanks for the vid! Using the wrong panel tools. Should get the squeeze handle kind that way it wont gouge the bottom of the door panel when prying. Pick tools work good for removing the cap behind the door pull without damaging it.
I’m here to help.
Those clips your popping off, just please stop doing that.
Majority of not all panels are built to twist or slide up, especially in 2011 up cars due to Alldata-
Pause I’m at 7:02 of your video and I had to pause it, this right here you done damage.
Always Slide up PANELS.
Always remember :
Door panels go up or twist-up
Arm panels go rear wards
Kick panels will click but always slide rearward
Convenience tray(cup holders trans shifter area) slides rearward
Dash gos up fwd
Dude behind the camera is a pain in the ass for the guy actually doing the work
I just pulled apart and reinstalled the panels on my ‘06 Harley Davidson F150 without damaging or losing a single clip, those Focus panels look and sound very tight…
PLEASE HELP ME!!! Thank you for all your videos they have helped a lot however I am stuck on how to install passanger glass on my 2012 ford focus... Is there a treat to reconnecting glass to the plastic clips that I believe are part of the window regulator
why is it so complicated? crazy. good video thanks
Great vid, thanks!
My door got over extended and now the lower hinge bent outwards a bit, causing there to be no gap between the door and the front fender - the stick trick doesn’t work with the focus because of the way the hinge is made… any ideas?
Do all Ford Focus have the electric window problems?
I have a 2005 and either the driver's window does not go down consistently or the passenger side doesn't go up consistently or jams half up or half down.
Can you suggest a car with no electric window problems?
It is costly to get them fixed.
A new motor was put in and then I was told it must be the electrical system
😔
Perfect video thanks buddy. Help me loads
Are you please able to show me how to raise my driver side window? It's stuck down in the door, the switch is broken (I think) and it's freezing cold, I have a cardboard window now for 4 days. Just need to get that window back up out from inside the door and pull back up to closed position. Thank you
This helped a lot! Thanks!
Great info thank you
There is a screw behind that flair
Can you do a video on how to replace the door handle on one of these
You helped me a lot. Thanks
Would love to see a Sill Removal for a focus. Thanks
DAMN it's a whole lot more complicated with electric door and Windows n shit. What happened tothe days when you just took out a few screws and pried the panel off and worked around the minor hardware. And the only tools you need were a Phillips head and a flat head😟 Lol
What happened? Well, for the past 20 years cars have been improved and manufactured with higher quality parts.
Excuse me man,hoy many inches are the speakers?
Best video
THERE IS A HOLDING SCREW BEHIND THE RED PLASTIC REFLECTOR YOU NEED TO REMOVE, NOT JUST TEAR OUT.
Found part broken in door replacement drivers side
El altavoz es 17 pulgadas
You sir are a hack. I almost broke multiple parts following along with your video. Why would you make a video on how to do something when from the start you had absolutely no clue what you were doing. If that was my car you were working on, I would have been mortified to watch that.
Une vraie galère 😢😢😢
Doors will not Latch possible safety
Left out a lot of important steps man.
I swear these are the worst cars
F...en Ford...
*nice but to much ok ok ok ok ok ok...ok ok*