Cada empresa tem seu trabalho... não sei se o silicone pode racha a borracha...Onde eu trabalho sempre uso silicone acaba melhorando nas retiradas das peças saudações a todos operadores 🇧🇷🇧🇷
Man you need a safety door so you can't move any of the plates or the mold without the safety door down. The way you pulled that purged material while the mold was closing could end really bad someday.
5 minutes for demolding of parts. Way too long and the mold & machine should have been designed for quick change over / demolding in mind. capacity can be doubled and tooling costs halved by a smart design. Let Kaizen begin...
Way Way too much time just removing the material in your machine.I counted over 40 seconds to just remove the runner and excess before your employee removed the actual parts.+your mold is cooling down at least 20+degree's before the next cycle. Cg.the best in injection, transfer and compression molding.35 years in all injection materials.
![Felix "Unfair" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/Oswujxm2Ag0/mqdefault.jpg)
Cada empresa tem seu trabalho... não sei se o silicone pode racha a borracha...Onde eu trabalho sempre uso silicone acaba melhorando nas retiradas das peças saudações a todos operadores 🇧🇷🇧🇷
What materials are used?
What is the formula or mixture used?
Its too long for the process makes temperature of molding going cold..
You should fast..
Bhai teri cycle time kaha ja rahi hai.
Ek shift me 2 cure hi kholo ge kya bhai
Bhai spray lga lo bottom mai jisse Sare part center plate mai aayenge
What materials are used?
What is the formula or mixture used?
👍👍👍👍
Pl tell me about machine for shoe sole make 600 gm shot size
Moldeo de inyeccion por transferencia para gomas , yo desarrolle un molde similar a ese
Ye company kaha hai sir
Well done sir
In a factory in Turkey, the workers dont wear any mask...
Lama diluar produk undercure
Ridiculously long process. Using expensive equipment better for other stuff.
Yep...alot of time and temp lost between cycles
hi
Well done use gloves.
Man you need a safety door so you can't move any of the plates or the mold without the safety door down. The way you pulled that purged material while the mold was closing could end really bad someday.
Tem sensor, acho que vir no vídeo geralmente essas máquinas tem para não evitar acidentes
I saw that he could put his hands into moving plates without it stopping. I saw a guy lose 3 fingers like that.
5 minutes for demolding of parts. Way too long and the mold & machine should have been designed for quick change over / demolding in mind. capacity can be doubled and tooling costs halved by a smart design. Let Kaizen begin...
It takes me 3 mins from the taking parts out , stripping rubber and reloading with 3 mins to spare. But u can't knock his job
What is the formula or mixture used?
Ilan hawak u machine 2 o 3
Bhai monocode laga le
Way Way too much time just removing the material in your machine.I counted over 40 seconds to just remove the runner and excess before your employee removed the actual parts.+your mold is cooling down at least 20+degree's before the next cycle.
Cg.the best in injection, transfer and compression molding.35 years in all injection materials.
If your paying the guy 3 bucks an hour who cares?
He probably pays for his hour of work in half a cycle.
What a bullshit material to work with compared to other plastics