Looked like you were a pretty quick master baster. :) .Seriously though, thx for the video. My brakes are doing the same thing and all I did was put a new brake cable on and bleed the brakes. It may have been going from DOT4 to 5 that toasted the seals.
For some reason, I can't get the bigger (2nd) seal to go back into the cylinder hub, it's as if the seal is too big for the hole. I checked and re-checked the position and A & B seal on the piston, but it won't pop back into the cylinder bore like you did. The first one popped in, but the second seal seems to be too big. Is it the wrong sized seal? Anyone else have this problem? Thanks!
Dude you are my hero
Looked like you were a pretty quick master baster. :) .Seriously though, thx for the video. My brakes are doing the same thing and all I did was put a new brake cable on and bleed the brakes. It may have been going from DOT4 to 5 that toasted the seals.
For some reason, I can't get the bigger (2nd) seal to go back into the cylinder hub, it's as if the seal is too big for the hole. I checked and re-checked the position and A & B seal on the piston, but it won't pop back into the cylinder bore like you did. The first one popped in, but the second seal seems to be too big. Is it the wrong sized seal? Anyone else have this problem? Thanks!
Where did you get your stand and spools? Or what is your setup on the rear?
Are the steps the same for the rear?
So did it work?
***** great to hear that it worked :)