So, you have two options, you either buy a hub from amazon which is $50, or you make the hub yourself. I made my own hub with a 5/8'' spacer and welded it to the drum brake. You can also use lock collars but keep in mind, the axle is 15mm in diameter and the spacer or lock collars are 5/8''. So, try your best to center it up on the drum brake. I also made my own jackshaft to help align the sprocket on the engine and the axle. I do have a video on this, I think its part 4 or 5 were I do this. You can also check out my newer video where I build another one of these trikes. Part 4 is what you're looking for.
What is need on a 3wheeler,is how the drive sprocket is installed on rear drive whees axle ,show how motor drive sprocket aliens with 32 teeth axle drive on rear axle. Could you do a flim on it. Thank you from little bill
So, what you are going to have to do is create a hub for that sprocket that can then mount to the axle. I used the sprocket (the one from the engine kit) to trace out the bolt pattern on a piece of metal, then drilled the holes and wielded it to two shaft collars. You can use any sprocket you want, just as long as you have a hub for it and that can mount to the axle, if not, you have to create one. I do have a video of me creating one so you can get a better idea, I think is part 7 or 8 of this build.
I'm trying to build the same thing I'm having a hard time getting the gear for the rear end
Hi little Billy here I'm putting a 100cc on a trike and can't figure how to install rear sprocket to back axle drive.
So, you have two options, you either buy a hub from amazon which is $50, or you make the hub yourself. I made my own hub with a 5/8'' spacer and welded it to the drum brake. You can also use lock collars but keep in mind, the axle is 15mm in diameter and the spacer or lock collars are 5/8''. So, try your best to center it up on the drum brake. I also made my own jackshaft to help align the sprocket on the engine and the axle. I do have a video on this, I think its part 4 or 5 were I do this. You can also check out my newer video where I build another one of these trikes. Part 4 is what you're looking for.
What is need on a 3wheeler,is how the drive sprocket is installed on rear drive whees axle ,show how motor drive sprocket aliens with 32 teeth axle drive on rear axle. Could you do a flim on it. Thank you from little bill
Basket that was funny happened to mealot
The sprocket that come with my motor goes on a wheel and I can't use that on my trake
So, what you are going to have to do is create a hub for that sprocket that can then mount to the axle. I used the sprocket (the one from the engine kit) to trace out the bolt pattern on a piece of metal, then drilled the holes and wielded it to two shaft collars. You can use any sprocket you want, just as long as you have a hub for it and that can mount to the axle, if not, you have to create one. I do have a video of me creating one so you can get a better idea, I think is part 7 or 8 of this build.