I have a question for you, I have a M8 2017 and they run not as lean as a twin cam. There is about a 10% leeway on the M8. My question is if I put slip-ons with a high flow Air filter do I really need a tune? Remember I'm still using my M8 cover so the air flow would be a little less then say an full open Air filter. Thank you and nice videos
I have installed pipes and air filters on m8 before and sometimes the bike handles it just fine. You can install them and see. A good test would be to take it on a test ride and listen for deceleration backfires. roll off the throttle and don't pull the clutch in. As the engine is winding down it shouldn't backfire. The more it backfires on decel, the leaner it is. A couple little quiet pops is ok, but backfiring is not good and you will need to tune it until the backfire goes away. Good luck with your project!
@@WrenchesCorner this answer is good to know. The previous owner changed the pipes on my new to me 1998 FLSTC, it runs good until the plugs become to fuel fouled like it’s burning rich. I’m going to clean the air filter first before trying to tune it. Today I put in new plugs instead of cleaning them again. But the bike does have some subtle backfiring on decel? Enough to notice. She also seems weak like she doesn’t start fast and she is sluggish from the stop. 34k miles on motor. What’s your take wrenches corner?
@AbersonPlastering Hi, I would check the intake manifold seals for leaks. It probably has old seals and need to be changed. Leaky intake can cause decel backfire. If you spray starter fluid at the intake where it goes into the engine ( after it warms up), it will try to stall the engine if they are leaking.if you have a lean conditon backfire and still fouling plugs, I would probably think about changing out the ignition system. A bad ignition system can foul plugs. Also low compression can foul plugs. Check compression. You could also need a carb clean. Good luck with your bike!
Just took my Lowrider S to get the 5000 mile service ‘bike came back with the oil filter looking the same so I’m here thanks for the upload.
Glad it helped! Thanks for watching!
Great video. Helpful and straight forward.
Glad it was useful! Thanks for the support!
That was great! Thank you for posting!
You're welcome! Thank you for watching!
what wrench did you use to remove the filter? Mine is stuck on so tight I cant get it off..!
You can use a socket type allen or torx bit. Those angled allen wrenches don't work as well. Good luck!
Should it be oiled if its a Vance and Hines filter?
Yes, they need to be oiled after cleaning and drying out. Thanks for watching!
Great video. Enjoyed it !
Thanks for the support! Glad it was helpful.
Great video thank you
Glad it was helpful! Thanks for watching!
For the stainless steel version, is it safe to use the k&n filter oil in red?
That's not a problem. Thanks for watching!
I just got the Arlyn synthetic so I don’t have to deal with any of this
You still have to clean and oil synthetics!
@@WrenchesCorner just bought the Arlyn synthetic one was under the impression that I didn’t have to oil it 😳 good to know now lol 👍🏼
I have a question for you, I have a M8 2017 and they run not as lean as a twin cam. There is about a 10% leeway on the M8. My question is if I put slip-ons with a high flow Air filter do I really need a tune? Remember I'm still using my M8 cover so the air flow would be a little less then say an full open Air filter. Thank you and nice videos
I have installed pipes and air filters on m8 before and sometimes the bike handles it just fine. You can install them and see. A good test would be to take it on a test ride and listen for deceleration backfires. roll off the throttle and don't pull the clutch in. As the engine is winding down it shouldn't backfire. The more it backfires on decel, the leaner it is. A couple little quiet pops is ok, but backfiring is not good and you will need to tune it until the backfire goes away. Good luck with your project!
@@WrenchesCorner this answer is good to know. The previous owner changed the pipes on my new to me 1998 FLSTC, it runs good until the plugs become to fuel fouled like it’s burning rich. I’m going to clean the air filter first before trying to tune it. Today I put in new plugs instead of cleaning them again. But the bike does have some subtle backfiring on decel? Enough to notice. She also seems weak like she doesn’t start fast and she is sluggish from the stop. 34k miles on motor. What’s your take wrenches corner?
@AbersonPlastering Hi, I would check the intake manifold seals for leaks. It probably has old seals and need to be changed. Leaky intake can cause decel backfire. If you spray starter fluid at the intake where it goes into the engine ( after it warms up), it will try to stall the engine if they are leaking.if you have a lean conditon backfire and still fouling plugs, I would probably think about changing out the ignition system. A bad ignition system can foul plugs. Also low compression can foul plugs. Check compression. You could also need a carb clean. Good luck with your bike!
@@WrenchesCorner thank you so much. I’m going to try all of that
3:19 My Harley Screamin Eagle is defiantly oiled.
Right, I should have said the stock Harley air filter doesn't get oiled. Thanks for watching!
How about a leaf blower for quick drying
You should let it air dry. You can blow fiberglass out of it. Just plan on doing it when you can allow it to dry naturally. Thanks for watching!
Awesome thanks for the help man
No problem! Thanks for watching!
Sweet thank you I ordered a used one on eBay it’s pretty dirty
Glad I could help! Thanks for watching!
Are ?? the grey arlen ness suppose to be oiled ????
The Arlen ness filters are supposed to be oiled as well. Thanks for watching!
Not synthetic air filter no oiling
I believe Harley screaming eagle air filters ARE made my K&N... And ARE Supposed to be oiled.
Right, Only the air filters that look like cotton shouldn't be oiled. Thanks for watching!
❤❤❤❤❤❤❤
Thanks for watching!
I should've watched the video first...I accidentally saturated mine...🤦♂️
I hope you found it helpful and thanks for watching!
So did I. Now I feel the need to reclean it. So much oil wasted.....😫