Sir could you please tell about inductors and wire gauze and magetic core how to find for example 3.7v to 5v boost converter to make in this regard how to calculate. Plz suggest
Macho, habemos muchos que el lenguaje de los gringos, ni papa, ósea que te pongas las pilas y pienses en los demás que no tenemos ni idea del ingles. Un saludo, suscrito y LIKE.
Please someone answer my question. I tried to make this but my wires were too small to carry any current from my battery, my battery was fine and it would send current through a 14 guage wire. But how can it pass through the inductor when the wire making it is so tiny
@ Tech Ideas Can you make with high output voltage like from 12 v DC / car battery (30 amps input), out put DC voltage around 35 and 48 volts with 5 and 10 amperes output Can make a video with circuit Diagram ?
A way late response but biggest role in here is MOSFET or BJT and also Coil to get higher amperage you would need more turns on Primary coil and Feedback coil and you need to use more expensive MOSFET or BJT that have high switching speeds higher the switch speed better the performance also you need high capacitance Capacitor so it can hold bigger charge. basically high switching speed will provide more power in general and will charge high capacitance capactior really fast high capacitance combined with better coil and mosfet or bjt will give much more power in the end when running on load also keep in mind the power lost as heat in mosfet or bjt so better cooling on them and youre set its really easy but needs better components hope i helped somehow :)
boost converter need a feed back system so that voltage wont drop with change in load (duty cycle will increase / decrease with change in load). this can be use to demonstrate boost converter but its efficiency will be very low which mean your cell will be dead with in mints.
Am I correct to say this is basically a joule thief? I can never get a joule thief to work but the way you did it here help me understand it better. I am going to try it.
its a type of joule thief, if never worked for you it's probably because you don't wind the coils at the same direction, also you can do it with a 555 timer easyer.
@@ruksanaparveen6342 I tried this and it works to boost the voltage stored in the capacitor as shown. In a practical application, a higher frequency, automatic cutt-off such as an oscillator would take the place of the manual switch. To see an example of a simple automatic circuit, google "Joule thief"
Simpler stationärer Aufwärtswandler, wie er in Elektroautos eingesetzt wird. Aber schöne Veranschaulichung! Bitte auch mal mit dynamischen Betrieb aufbauen 😃
If it goes above 20v why doesn't the LED gets burnt out , last time I used 9v battery on a 3v led , it gets damaged , please explain sir , I'm in confusion
if u switch the position of inductor and transistor, and flip the diode so it blocks positive voltage from battery to caps, the rise in voltage won't be accompanied by currrent draw from battery, which simply means more output than input.
If that was a rechargeable AA1.5v and it's producing 20v, could any of that voltage be routed to a battery charger for the 1.5 or is amperage too low? If so, it would violate 2nd law of thermodynamics and other laws I don't quite understand but it would produce energy until life of battery but if it's that easy I'm sure someone would have made it long ago then turned it into a weapon
no es un ladron de julios, es un combertidor boost, en el ladron de julios se usan 2 bobinas con una conexion enlazada, en el combertidor boost es simplemente una bobina con sus 2 extremos
From this video I learned those voltage ratings for components arent accurate, more like minimum voltage with a rated wattage, he put a 20v source on one diode...
Sir ac non tuch testor aisa banye jo 5 miters dur se hi indicket karne lage sir kheto me achanak 230 volt tar gira rahata hai jo hame 5 bar Mar chuki hai sir please 2 din me banaye
Наука
Excellent lesson!
i like your simple component 👍
OH MY GOD thank you soooo much
I was stuck on this fo months
Quantas voltas tem essa bobina ou aonde encontro uma dessa ?
@Tech Ideas , Würde gern wissen wieviele Windungen primär? Would like to know how many winds on primary?
thank you so much!!! i was stuck on this topic for 4 days...now im clear about this
What is your project can you tell me please
Can I use bc547 npn transistor by replacing d882 transistor
No you you can't
Can I use d42030 transistor?
ICREDIBLE!!!!
BRAVO!!!
I have so many ideas for this tiny circuit , i mean , practical applications!
thank you!!!!!!!
Welcome
Sir could you please tell about inductors and wire gauze and magetic core how to find for example 3.7v to 5v boost converter to make in this regard how to calculate. Plz suggest
its nice demonstration of Boost converter circuit , please make video same like this on Buck converter
Macho, habemos muchos que el lenguaje de los gringos, ni papa, ósea que te pongas las pilas y pienses en los demás que no tenemos ni idea del ingles. Un saludo, suscrito y LIKE.
cuantas vueltas le has dado a tu bobina y que numero de alambre
The best... valeu.
🙏nice teach sirji 🙏
Can I use d42030 transistor
How to wind this feed back coil?
My toroid farite core never seems to work, always showing inductor test below zero value (0.08) in multimeter. Can u advise some inputs..
Hello can i use other transistor like S8050
You can turn on led light at >20v? in my case my led explode when connet to 9v battery
Bruh it has low current what do you expect
Great Job Keep up the great work. What is the power rating of the 12 V LED at the end?
20 W
Why you dont use a resister at the base?
Great Vidio...
Capasitor kitna volt ki hai ??
Can i use p55nf06 mosfet
Awesome!!! thanks
Where's the other end of the feedback? Are both ends connected to the base of the transistor?
1 end connected on the positive of cell .. And other connected on bass pin
@@SiddharthSingh-sk2md thank you sir.🖤
No lugar da pilha. Seria possível um capacitor? Polarizado ou não polarizado?
I tried this construction , not work !
What about using a crystal oscillator to do the switching?
i think it will work
how does the current limit itself in this circuit?
Well if you discharge the capacitor like he does and by connecting what you want to it but it could be the current is limited
superb .!!!!
Will there be hearing issue
Please someone answer my question. I tried to make this but my wires were too small to carry any current from my battery, my battery was fine and it would send current through a 14 guage wire. But how can it pass through the inductor when the wire making it is so tiny
I want to give you many likes, RUclips must have provision for that. I like use of mechanical switch to demonstrate. MOSFET switching
Perfect thanks
finally thank you friend :P it works!
Can I use 13003 transistor instead of d882?
Yes,
@ Tech Ideas
Can you make with high output voltage like from 12 v DC / car battery (30 amps input), out put DC voltage around 35 and 48 volts with 5 and 10 amperes output
Can make a video with circuit Diagram ?
A way late response but biggest role in here is MOSFET or BJT and also Coil to get higher amperage you would need more turns on Primary coil and Feedback coil and you need to use more expensive MOSFET or BJT that have high switching speeds higher the switch speed better the performance also you need high capacitance Capacitor so it can hold bigger charge. basically high switching speed will provide more power in general and will charge high capacitance capactior really fast high capacitance combined with better coil and mosfet or bjt will give much more power in the end when running on load also keep in mind the power lost as heat in mosfet or bjt so better cooling on them and youre set its really easy but needs better components hope i helped somehow :)
Excellent....
nice
I made this the input is 9v and the out put is also same what should i do now i used transistor 13001
check the transistor if theres a short
can i use any transistor
Excellent simple
Verygood
boost converter need a feed back system so that voltage wont drop with change in load (duty cycle will increase / decrease with change in load). this can be use to demonstrate boost converter but its efficiency will be very low which mean your cell will be dead with in mints.
Really, in place of cell what happened we're placed a 5V mobile battery
@@prabhas3054 it will die too , too quickly
i understood everything now thank you so much
hello , i tried it on circuit wizard but have no boosted voltage and almost no current
maybe ur transistor is shorted,or wrong wiring
Which inductor is this.
Am I correct to say this is basically a joule thief? I can never get a joule thief to work but the way you did it here help me understand it better. I am going to try it.
No, the circuit of a Joulethief is a other one.
its a type of joule thief, if never worked for you it's probably because you don't wind the coils at the same direction, also you can do it with a 555 timer easyer.
22222@_zzzzzzzxxx---'wdzsefSrwwwrQ-zX''aywszwwzewFEWWDWEEEWEYE2wWZXFFFz-_-f
ronald arias fernandez totally agree
@@adrianm9570 so you understood that? XD
Nice video. I will try to make it.
Did u make? If u made that did it work please say
Did u make? If u made that did it work please say
@@ruksanaparveen6342 I tried this and it works to boost the voltage stored in the capacitor as shown. In a practical application, a higher frequency, automatic cutt-off such as an oscillator would take the place of the manual switch. To see an example of a simple automatic circuit, google "Joule thief"
why not show coil canaction?
sir can i make my own inductor
How does the transistor get turned on and off automatically?
I also have the same question......
Yeah ..it makes no sense. Have you found an answer?
I also want to know
The coil is magnetic? Please reply I want to make this.. !
no
Simpler stationärer Aufwärtswandler, wie er in Elektroautos eingesetzt wird. Aber schöne Veranschaulichung! Bitte auch mal mit dynamischen Betrieb aufbauen 😃
am azi ng bro
We can make it with mobile chargers transformar
If it goes above 20v why doesn't the LED gets burnt out , last time I used 9v battery on a 3v led , it gets damaged , please explain sir , I'm in confusion
Good question
More detail about the coil please
my g really used microswitch in this project as the main switch
Наглядно показал работу транзистора, лайк
how long will the 1.5v battery run the 12v light?
Until the battery voltage drops below 0.59V.
@@TechIdeasAG any ideas how long that is? have you tried it? 1 minute, 1 hour, what???
Around 20mins, becoz the led will not glow in its full brightness
if u switch the position of inductor and transistor, and flip the diode so it blocks positive voltage from battery to caps, the rise in voltage won't be accompanied by currrent draw from battery, which simply means more output than input.
What the value of capacitor?
Depending on the cap some hold 35V and other can hold 50V
It doesn’t matter as long as its voltage isn’t lower than what the circuit can output you’ll be okay.
Will this circuit work for 0.9 volts
Ofcourse, you can try
Tô querendo botar um led de 70w na motoca e ele funciona em 40 volts. Será que vai funcionar?
Which transistor you used?
d882
A D882 npn transistor
So nice
Does this work?
revealing things of science
भाई क्या ईस से मोबाईल चार्ज हो सकता है
Good
Thank you
Load capacity ?
can I used 4 volts battery this circuit ?
Make this idea in ac volt without stabilizer .
Vai isma curent dhire dhire kam hi raha ha ak jaga par stop nahi ho raha..
make a video on coil winding of this video🙏🙏🙏
Sure 👍
This will really work any feedback
Sir wireless phone charger banao please
If that was a rechargeable AA1.5v and it's producing 20v, could any of that voltage be routed to a battery charger for the 1.5 or is amperage too low? If so, it would violate 2nd law of thermodynamics and other laws I don't quite understand but it would produce energy until life of battery but if it's that easy I'm sure someone would have made it long ago then turned it into a weapon
It's too low amperage
Cannot kill anybody with too low amperage
Yes volt up and amp down
But 0.1 ampear ke charger se lagane se kya ho ga 🤔
most simplest boost converter to make
Ladron de julios?
Julios thief, yeah!
no es un ladron de julios, es un combertidor boost, en el ladron de julios se usan 2 bobinas con una conexion enlazada, en el combertidor boost es simplemente una bobina con sus 2 extremos
@@jeremiasberrutti5453 me refería a que haga un ladrón de julio
how??
12 voltage fix banaye.
1:12
Are you sure that's 10 turns? Looks a look more...
🌹🌹🌹🌹
What for?
Collector current always Alfa times of emitter so it's amplify
I tried it but it didn't work
how many volts 100 uf capacitor
تابعو قناة TRAFIC H.I
From this video I learned those voltage ratings for components arent accurate, more like minimum voltage with a rated wattage, he put a 20v source on one diode...
Cara dapat deitnya gimna
?????
That's 20v to an LED? Wh- WHY?
I also have questions
@@EmmanuelGolden-qb8nh Sure, I'm all ears, ask me.
thi
Sir ac non tuch testor aisa banye jo 5 miters dur se hi indicket karne lage sir kheto me achanak 230 volt tar gira rahata hai jo hame 5 bar Mar chuki hai sir please 2 din me banaye
every video is very vague about the actual coil construction.......
because its simple lol
@@kingbrown7168 i mean , single coil, bifilar, centre tapped, gauge, windings, etc....lol..
CLICKBAIT