How to Install a Flute Head Joint Cork

This week we'll learn how to install a flute head joint cork on student flutes! This straight forward process can be done with a minimum amount of tooling.
Here are the different tools we used in the stream:
Bench Motor:
www.musicmedic...
Knipex DuckBill Pliers:
www.musicmedic...
Natural Flute Head Cork:
www.musicmedic...
Single Edge Razor Blades:
www.musicmedic...
Mallet:
www.musicmedic...
320 Grit Sanding Mesh:
www.musicmedic...
400 Grit Sand Paper:
www.musicmedic...
Digital Caliper:
www.musicmedic...
Wilmington Flute:
www.musicmedic...
MusicMedic Repair Courses:
www.musicmedic...

[@silpo4164]

Thanks from Patagonia Argentina. Silverio

[@andrewquirey7364]

Embouchure hole is term for the lip plate hole.

[@MusicMediccom]

Yes! Thanks for watching!

[@johnbutler6883]

I believe it to be essential to clean the head joint bore so the cork doesn't pick up debris when installing. There is also a debate on whether to bevel the crown end of the cork or not. I tend to do so. I also like to taper a wee bit when sanding to simulate the profile of the head joint. Thanks for posting.

[@MusicMediccom]

Awesome tips thanks John!

[@lois2911]

I did for mine too. A tapered cord for a tapered head joint is said to be best by some.🙂

[@leo5208]

Couldn't you use a little cork grease over the paraffin and then use the screw-on crown to fine tune the adjustment upward? I also suggest polishing the metal disk to a mirror finish while it's on the bench motor, just for the aesthetic value.

[@PleochroicRainfall]

Hiya guys! #fluteheadcork

[@MusicMediccom]

Hello! Great to see you!

[@brianjames2186]

#fluteheadcork

[@jamespinson875]

O man the smacking 😅

[@MusicMediccom]

😅

[@TornadoGarden]

Embouchure receptacle...

[@mactech44]

#fluteheadcork