BioProcessing mixing tank fermenter geometry creation in Ansys Spaceclaim

[@jiritichy6855]

I am learning and I would like to know, what command did you use to bring the screenshot onto the sketch plane... Thanks. "Import picture" doesn't fetch anything in help on line(F1) and just import fetches all kinds of other things, but the Import picture method. And from video it is not discernable...

[@franky0226]

Just drag and drop, It worked for me

[@meong1351]

Wow, nice tutorial, easy to learn!

[@ozgurbozkurt5945]

This was pretty good! Thank you! Can you upload the fluent setup of it too?

[@Alokkumar-ze7ry]

Plz provide full simulation. Thanks

[@jasonbrearey7284]

When adding the sparger, it will not allow me to select the face.

[@jasonbrearey7284]

When I go to create the circular baffles I get a pop up error “failed to create pattern”

[@drashar841]

the dia is 260mm as per the paper, but you have done some calculation and showing 140mm, can you xplain?

[@mohammedfoukrach6897]

Hi, i have a problem for a numerical simulation of agitated vessel (MRF method) Pre Processing CFX 15.0; can you help me please ?
DOMAIN INTERFACE: Domain Interface 1
Boundary List1 = Domain Interface 1 Side 1
Boundary List2 = Domain Interface 1 Side 2
Interface Type = Fluid Fluid
INTERFACE MODELS:
Option = General Connection
FRAME CHANGE:
Option = Frozen Rotor
END
MASS AND MOMENTUM:
Option = Conservative Interface Flux
MOMENTUM INTERFACE MODEL:
Option = None
END
END
PITCH CHANGE:
Option = None
END
END
MESH CONNECTION:
Option = GGI
END
END

In Analysis 'Flow Analysis 1' - Domain Interface 'Domain Interface 1': The interface is placed at a rotor-stator interface and the pitch change option of 'None' has been selected. This option should only be used when the overall extent and shape of each side of the interface perfectly match and the surfaces are aligned with each other. It may therefore be suitable when full 360 degree or exactly equal pitch components are being analyzed.
DOMAIN INTERFACE: Domain Interface 1
Boundary List1 = Domain Interface 1 Side 1
Boundary List2 = Domain Interface 1 Side 2
Interface Type = Fluid Fluid
INTERFACE MODELS:
Option = General Connection
FRAME CHANGE:
Option = Frozen Rotor
END
MASS AND MOMENTUM:
Option = Conservative Interface Flux
MOMENTUM INTERFACE MODEL:
Option = None
END
END
PITCH CHANGE:
Option = Automatic
END
END
MESH CONNECTION:
Option = GGI
END
END
In Analysis 'Flow Analysis 1' - Domain Interface 'Domain Interface 1': Pitch Change option 'Automatic' is not valid if side 1 or 2 of the interface has a 360 degree or greater pitch angle, zero radius, mesh faces normal and parallel to the rotation axis, or mesh faces at the hub curve (low radial or axial position) which are thin in the radial or axial direction.

[@SaulousHR]

what book or paper is it?

[@franky0226]

The paper can be found here :
drive.google.com/file/d/1lUamk8s52z2wyXY5M1W7bCqv1Qm0c2_A/view?usp=sharing

[@oliverxu5478]

bravo Asian voice loud!