Introduction to solidworks flow simulation : cfd analysis of convergent divergent nozzle

[@esquivel1]

The "inner wall" boundary condition suddenly appears @5:59 (around the 6 minute mark). How was this set? Also, How can I view the exiting air? I had a look at the previous comments/answers and I do not understand how to check the "analysis settings" or in better words, what settings to change. Please help :)

[@impactodelsurenterprise2440]

Yeah he didn't show how to set the real walls. You have to select the inner cone surface, leave out the inlet and exit boundary. Then, edit your Cut Plot, under the Contours, there is a small button to the right of "Pressure", click that and reset the plot max and min value

[@germangarrido8842]

That´s an interesting video. Thank you!

[@cad4fea]

Glad you liked it!

[@corneesmit7205]

But how do you simulate what happends when it exits the nozzle

[@makkihassan9118]

how to use solidworks flow simulation results as initial boundary conditions to perform anoth flow simulation based upon the results

[@LemonTreeNOTfree]

Thank you very much

[@reviewvideoes5006]

when i make the geomatry and opens it in flow simulation the error appears that please make a lid

[@cad4fea]

Ok, then please make lid manually in part model before ging to flow simulatin mdule.

[@jiml8120]

what is inlet to throat area ratio and exit to throat area ratio of this ?

[@eloymartin8970]

Same problem:
(((
my simulation is in "preparing model" and never ends - why does that happen? thanks!

[@cad4fea]

check analysis settings

[@eloymartin8970]

@@cad4fea WOw, Thanks! -___-

[@enghanan-t5l]

🥰🥰🥰🥰

[@MsMatheusrichard]

250 bar?

[@hilmonstiglet4157]

Cool

[@ty88]

Hello sirs
Pleased to be making the needful

[@cad4fea]

Thanks for visiting ansol

[@cad4fea]

Thanks

[@MsMatheusrichard]

Hydraulic system is about 80 bar, 250 bar is so much!

[@Andres-gr3us]

Fluids simulation with solidworks has no sense