This is a great video - thank you. For years, I have taken power supplies an attempted to use them as a bench power supply. I never connected anything to anything other than the 12 volt. Each and every time, sometimes sooner than later, the power supply would just shut off. I would have to disconnect the power to the the power supply, wait a while and reconnect for them to reset. But, as always, they would shut off. So, I did not see/hear any mention of this problem with your set up here. PLEASE tell me how you got around this issue?
The breakout boars should have been installed within the case and run wires to usb panel mount for a cleaner look
Really cool they have come out with quite a few new boards, I like yours but didn’t see it on Amazon, found close, do I ever need a 3d printer
This is a great video - thank you. For years, I have taken power supplies an attempted to use them as a bench power supply. I never connected anything to anything other than the 12 volt. Each and every time, sometimes sooner than later, the power supply would just shut off. I would have to disconnect the power to the the power supply, wait a while and reconnect for them to reset. But, as always, they would shut off.
So, I did not see/hear any mention of this problem with your set up here. PLEASE tell me how you got around this issue?
What was the pc psu that you used ?
where did you get that break out card?
I found all mine on eBay, TEMU and Aliexpress.