Thanks for the video, it helped me quite a lot because the instructions sheet are really bad. But after fixing the bar, when i wanted to assemble it, one of the rolling element bearing fell and i have no idea how to replace it. I can see where it was but the place seems too small to let it enter. If i just place it without forcing, it doesn't work, the tray doesn't clip in. Actually, i found 2 rolling element bearing on the floor...
Actually, this video was quite useful. Turn the speed down (in the "gear" menu" to 0.25 and watch). Esp good as this is the left-hand open installation where all the printed "pictograph" awful instructions are the opposite open. Printed instructions do say the left bar (mounted flat) should be 10mm off the deck though
Thanks for the video, it helped me quite a lot because the instructions sheet are really bad. But after fixing the bar, when i wanted to assemble it, one of the rolling element bearing fell and i have no idea how to replace it. I can see where it was but the place seems too small to let it enter. If i just place it without forcing, it doesn't work, the tray doesn't clip in. Actually, i found 2 rolling element bearing on the floor...
Hi sir, please contact us for this issue. Please send me some phtotos of the damage part. info@vadania.com
my cabinet has a 3/4 inch facing. Do I measure from the outer edge (meaning the facing) or from where the facing meets the actual cabinet?
Actually, this video was quite useful. Turn the speed down (in the "gear" menu" to 0.25 and watch). Esp good as this is the left-hand open installation where all the printed "pictograph" awful instructions are the opposite open. Printed instructions do say the left bar (mounted flat) should be 10mm off the deck though
Sar 1 pees price
How do you make adjustments! Mine isn’t going completely back leaving my cabinet door slightly ajar.
Hi, could you show me a video through our official email? info@vadania.com I can have a better check
What are the measurements in? mm, cm....??
mm
No size no dimensions 👎