AUDI A3 8P - How To Remove Gear Knob & Gaiter Removal Replacement 2004-2012

Guide on how to remove and replace the gear knob & gaiter from an Audi A3 8P (Mk2), years 2004 to 2012.
Part number for clip: N10255501
Tools used:
-Flat Screwdriver: amzn.to/3qRPuMn​
-Crimp Clip Pliers: amzn.to/2P9WKFM
-------------------------------
www.selectvehiclespares.co.uk
-------------------------------

[@SelectVehicleSpares]

Part number for clip: N10255501
Tools used:
-Flat Screwdriver: amzn.to/3qRPuMn​
-Crimp Clip Pliers: amzn.to/2P9WKFM

[@Ovitchz]

Thanks you man

[@Lee-eu6wf]

Tq

[@bdarrington1]

do you know the size of the selector when the knob has been taken off, like is it 10mm, 12mm, 16mm? I'm trying to pick an aftermarket knob to put on and this would help a lot :)

[@SelectVehicleSpares]

Hi, no sorry, we no longer have the vehicle in the workshop, so couldn't say for sure what size it is.

[@user-gx2yu7bh7o]

It is a must to squeeze that thing first before eventually putting the collar back on right. Because i can't seem to be able to put that collar in place, it's almost as if it doesn't want go in and i have to use massive amount of force. Maybe if i squeeze the N10255501 first then I could potentially be able to put the collar where it has to be. What do you think?

[@SelectVehicleSpares]

Yes, if you squeeze the clip first, and then once it is tight you could try to squeeze it again with some grips so it doesn't stick out as far, this should help get the collar on easier.

[@surellow]

Can i just use end cutting pliers for the clip instead of crimpers cuz i dont have them

[@SelectVehicleSpares]

Yes, we've used them before to do the same job. You just have to do it gradually from each side bit by bit.

[@surellow]

@@SelectVehicleSpares Thanks brother i replaced it looks much better now