Ryobi 2700 pressure washer, adjusting for low pressure, works on all pressure washers
HTML-код
- Опубликовано: 12 сен 2024
- When your pressure washer starts losing water pressure it may need adjusting. There is an adjustment screw or bolt on the water pump. This adjustment will work on any pressure washer.
This "almost" helped me with my Ryobi Washer very low pressure. I wish you would have showed WHICH WAY you were turning that adjuster nut as you were decreasing/increasing pressure.
turn it to the right for more pressure and to the left for less pressure, Thanks for asking and thanks for watching
@@dustyguy Thanks !
@@shanew.williams your welcome
You may have a stopped up pressure valve, if you can take it the pressure nut and spring all the way loose, NOT OFF, and see if the engine die when you pull the trigger. Then you probably have a stopped up valve. or pump
or a froze up pump from using the wrong chemical
My pressure washer dies when I release the trigger ryobi 3300 bought 3months ago
@@Daverodd06 Pressure valve may be set too high , turn down the pressure
not 100% clear to me. I assume you are increasing pressure by turning large 15 m hex cw. don't you have to hold centre threaded rod so big nut threads on it? can't do that using a socket over everything. then locking in place by getting the little nut on tight, again while holding threaded rod.
What about the nut falling off at 1:32? Isn’t that important?
And it was still missing when he put the cover back on .
Thank you! Been kicking mine, but that stopped working!
adjust the pressure relief spring
Thanks
Your welcome
You're losing a lot of pressure at the wand?
Loosing a lot of something
Hi i got a pressure washer that starts right up but the pressure that comes out from the gun is to low and when i squeeze the triger it shut off any idea what could it be?? I did the oil change,spark plug,add new gas,new air filter
If you can find the pressure valve and back the nut out start it up and adjust the pressure nut higher a little at a time and pull the trigger see if it changes the pressure. If that doesn't help let me check mine and see if I see anything tomorrow
@@dustyguy ok thank you i appreciated ...im gonna do what your telling me hope it works👍🏼
@@dustyguy also when i turn the nut the whole loader valve moves
What if you throttle too high for your pump??
I would not tighten the pressure nut too much. You will be able to tell if you have the pressure set to high because the engine will start to bog down. If it does back off the adjustment screw