The E1 code would come up and switch back and forth between it and the cooking temperature for some reason. I switched it off for a few min and gave my pan a good scrub underneath. Also recleaned the surface and it worked fine after that. Its been working wonderfully for the last year so i wasnt sure why it did that. I know E1 comes up if you dont have a pan on the surface or a non magnetic one. Sometimes it just needs a reset. Don't panic!
Could low voltage of say around 100 to 120v make the cooker not to heat up red? Also could voltage fluctuation make the e1 or ea come up ? Can using a voltage stablizer solve these problems
check with multimeter the wavy element (big circle ceramic) if it wavy element burnt / corrosion / broken in the middle . there's should be a connection from both ends
The E1 code would come up and switch back and forth between it and the cooking temperature for some reason. I switched it off for a few min and gave my pan a good scrub underneath. Also recleaned the surface and it worked fine after that. Its been working wonderfully for the last year so i wasnt sure why it did that. I know E1 comes up if you dont have a pan on the surface or a non magnetic one. Sometimes it just needs a reset. Don't panic!
Thanks bro very useful your video
Thanks alot
I did this and it worked , and yrs maybe oily food erupt it
Could low voltage of say around 100 to 120v make the cooker not to heat up red? Also could voltage fluctuation make the e1 or ea come up ? Can using a voltage stablizer solve these problems
check my other video E3 error capacitor to test each component, aplicable to E1, E5, and other issues
Thanks a lot .
E3 error for any induction cooker issue is the same?
this one is infrared, induction have different sensor, but similar.
I see, could you check E3 error for induction Tefal ih7208?
can i get catalouge(manual) full please.
Can clean it with other cleaners?
How to purchasing this heater parts ?
Pak, jadi error e3 itu penyebabnya apa ya? Kompor saya sudah lama beli tapi baru dipakai sekarang.
sensor tengah kotor atau tidak ada koneksi. coba di tonton videonya
What about E4 code. It shows after 2 minutes.
Это не индукционная плита а просто керамическая
When my Siemens induction show 1 and 9 wat can i do
E9 usually error in control board, need to check inside, failing component or just simply loose connection /rusty legs. watch my video part 2
What about E2 error
sir paano po ayusin if ayaw na uminit po?
check with multimeter the wavy element (big circle ceramic) if it wavy element burnt / corrosion / broken in the middle . there's should be a connection from both ends
Kalau keluar angka E8 apanya y boss
banyak kasus E8 ada satu resistor terbakar. bbrp merk ada yg rectifiernya putus. hingga coil pemanas putus. thermal sensor lupa pasang juga muncul E8.
@@addiengr1 okeyy makasi infone boss... Sangat membantu sekali ..