Hi bro, thank you for sharing your design. I have a question: is that Flat Profile Keycap really necessary? Can I just use Actuation Plate alone to press switch?
@@keyhubkb that's the part that has me, did you design a single pcb and have it manufacturered locally or something? I've found some online that have 5x5 layouts that seem like you could "snap" one off but it also appears to possibly be traced together.
this is awesome man, thank you for sharing
so what ajustments do i need to do to fit in long poll switches ??
is using PLA fine for the motor? or will it run so hard that it warp the print
Hello, I wanna ask if the motor and the Female USB C to 2-pin 22 AWG Wires are soldered?
They are soldered by you after procuring both parts
Hi bro, thank you for sharing your design. I have a question: is that Flat Profile Keycap really necessary? Can I just use Actuation Plate alone to press switch?
If you check out the operational guide video, it shows that the flat keycaps in addition to the plates are in order to perform off center actuation.
@@Someguy5k Got it! Thank you, bro!
Hey can i ask a question. That 30% infill will be enough ?
where did you get that motor?
What parts did you use to count the switch depresses? Was there a kit or do you have a bom?
I made a hotswap pcb to pair with one switch and track when it depresses with an ESP32 development board
@@keyhubkb that's the part that has me, did you design a single pcb and have it manufacturered locally or something? I've found some online that have 5x5 layouts that seem like you could "snap" one off but it also appears to possibly be traced together.