How to Install an O’Hagin Vent on a Roof | Shingle Roof Install Guide
HTML-код
- Опубликовано: 9 июл 2024
- In this video we’ll show you how to install an O’Hagin vent, also known as a low profile roof vent.
Proper roof ventilation is one of the best ways to increase your roof’s lifespan. There are lots of roof vent types, but whether you install a dormer vent, O'Hagin, or eave vent, make sure to install the vent properly, because adding attic vents will be very beneficial for any roof.
0:00 Intro
0:10 explanation
1:15 locate where to install the O'Hagin vent
2:30 measure and cut the opening
4:14 install mastic around the opening
5:00 install the O’Hagin vent
6:18 install ice and water shield
8:55 install shingles
11:58 water test
This video is from our latest series, “The Shingle Roof Install Guide,” where we will walk you through every step of the process when installing a brand new shingle roof. From the drip edge to ice and water shield, from starter strip to flashing, we will give you all the details on how to install a shingle roof.
Full playlist: • Shingle Roof Install G...
We are a licensed and insured roofing contractor based in Burbank, CA, so keep that in mind when you watch our videos, as roofing regulations are different across the country.
We service the Los Angeles area, and if you’re looking for a trusted roofer, be sure to contact us today for a free estimate!
Contact Us!
► Facebook: / roofrepairspecialist
► Instagram: / roofrepairspecialist
► Read our Google ratings: bit.ly/34bQrVP
► Read our Yelp ratings: bit.ly/3mZChzP
Musicbed SyncID: MB01DPKMFCT9MVJ 
Хобби
![Skilla Baby - Misfit (Feat. Polo G) [Official Video]](http://i.ytimg.com/vi/IjsylSnNMyw/mqdefault.jpg)
Please like this video and leave a comment below if this tutorial was helpful!
Nice looking product and a solid instalation. Right down to the dog ear.
Thanks 👍
Nice video. I don't see why the mastic should go over the underlayment unless it is I&W shield. Any water under the underlayment will go into the attic. Underlayment is penetrated by thousands of nails and so is not a reliable water barrier.
How about putting a bead of sealant vertically a bit underneath the shingles to ensure no lateral seepage?
Great video. I have these on my new home built by Taylor Morrison in North Las Vegas NV
Thank you!
Please make a video on a fully shingled roof to follow proper instructions would really be helpful.
We do have that. However it’s comprised from a bunch of smaller videos. We also have a playlist with all videos combined. Check it out and let me know if I’m missing anything
Do you have a video of installing a kitchen rooftop blower box?
I do, it’s the t top video
Are there pitch limitations to using low-profile roof vents? The roof replacement I am designing only allows for a 1/2" per foot pitch increase from the existing flat roof.
This vent is definitely not for that. I think the minimum is 2/12 pitch.
Was looking on youtube for a O'Hagin vent (on a roof quote I got) and came across this video. Very informative and see the quality of your install. Wish you were up here in the 650 area code (bay area). I'm replacing a roof and installing solar. Didn't like the quote sfrom the contractors that does both. They either didn't give details on the or the solar. Should I consider hiring a roofer and then go with Tesla to do the solar?
That's probably what I would recommend. Solar guys usually don't employ roofers, they usually sub contract the roofing out. I think hiring a reputable roofer and having them coordinate with the solar company, Tesla or whoever would be your best bet.
@@RoofRepairSpecialist thank you for you quick reply. I saw another video where you mentioned being an owens corning installer. Must be good stuff. All my quotes have been GAF or Certainteed but will see about getting a quote on OC. Have a great week!
Are the fire an ice ones the same as the one you put on? If not do a video on it
They are installed the same exact way.
How much square foot of space is the vent good for. Also if the vent is considered as a air intake do you need a exhaust on top of roof?
That is a difficult question to answer. Depends on the state and the codes you have. California has two options for venting, 1) intake and exhaust 1/150 2) Cross venting is 1/300.
You can use Ohagins as Intakes and exhaust, depending on where you place them. Intake at bottom exhaust at top.
Here is a calculator that would help. ohagin.com/vent-calculator/
After installation do I expect to see dim sunlight through the low profile vent once I enter attic?
I think depending on the time of day and angle of sun, yes
I have those vents but they look like they’re closed .how do you open ?
These vents are static, meaning they do not open or close, they are always open.
Could you install this along with a ridge vent.. or is it one or the other?
You can install both, especially if these vents are lower on the roof and act as a intake. However it is not the best solution as these vents are not the best intake vents. Venting is complicated and a whole science behind it.
@@RoofRepairSpecialist Oh, if you don't have one, could you please make a video on installing the best intake vents for your roof? 🙏🙏🙏 That would be a great video! What is the best intake system you would use with either a ridge vent or a low profile vent?
I do have a video on a Owens Corning Intake Vent. My favorite intake vents however are not even on a roof, it would be a soffit/ eave vent.
I plan on doing a video eventually on venting science, however I still need to do some learning myself, venting is a complicated business.
Can you use O”Hagen as an intake vent?
You can, it does meet code, however it doesn't preform the best as a intake from what I have heard. However don't know for certain, more hear say.
How much does one of these vents typically cost these days?
I think they are around 50-80 dollars, however install can range allot.
Only issue I have with this is ice backing up in that opening
I'm not sure how these vents preform in ice/ snowy conditions.
can we add solar panels on top of these vents?
Yes.
@@RoofRepairSpecialist Does adding a solar panel on top of the vents creates any problem to either the roof vents or panels?Just wondering, what if we need to remove/ replace the vents if something is wrong.
My only question is how do you prevent rodent and animal intrusion?
The vents have built in screens that prevent rodents getting in. Most new vents do.
Whats the best place to install them?
That is a complicated question. If you have eave vents and are using them as a exhaust then within 2 ft of the ridge. If you don’t have eave vents then I think the 1/3 down from the ridge in a staggered pattern. You don’t want them back to back
Why 11x11 square ???
That’s what manufacturer calls for.
É
?
what a goof as you first determine where the rafters are and go in between them.. Yeah, it's bulletproof but you can also run shingles on top of the o'hagin so water or snow don't sit behind o'hagin in a channel;; another thing; its for looks and how it's supposed to be done.... Don't let this dude show you how to do one on a Tile roof lol
Sounds like you know what your doing.