Making a Unique Tabletop Inlay on the LongMill MK2 CNC
HTML-код
- Опубликовано: 4 окт 2024
- Are you looking for a project that does not require a lot of programming? In this video, Dennis Harlock shows us how to easily take an oddly shaped piece of wood and turn it into a unique tabletop inlay using the LongMill.
Chapters
0.00 - Introduction
0:44 - Explanation of Project
1:15 - Pine Block for Clamps
2:16 - Tabletop Inlays Explanation
3:01 - Clamping Down Workpiece
3:31 - Using Sticks to Fill in Gaps
5:08 - Homing Using gSender
5:51 - Finding A-side and B-side Coordinates with gSender
7:17 - Creating Lines and Toolpathes with VCarve
10:45 - Using the LongMill to Cut Lines
11:59 - Cleanup/Finishing of Inlay Carves
13:25 - Chopping/Sanding/Tapping in Sticks to Fill in Gaps
14:28 - Outro
// Resources
Know the End Mill Starter Set
sienci.com/pro...
Know the Crafters End Mill Set
sienci.com/pro...
Know the Machinists End Mill Set
sienci.com/pro...
Know the new AutoZero Touch Plate
sienci.com/pro...
Know the LongMill MK2
sienci.com/pro...
LongMill Resources Page l Sienci Labs
resources.sien...
// FEATURED TOOLS & SOFTWARES
▸resources.sien...
// PROJECT IDEAS
▸ resources.sien...
// JOIN US
▸ Sienci Community | forum.sienci.com/
▸ Facebook Group | / mill.one
▸ Instagram | / siencilabs
Hashtags:
#siencilabs #longmill #cnc #milling #tabletop #geometricalshap #inlay #project #tutorial
I like your idea of insetting pieces instead of the standard epoxy pour. I've two suggestions: 1. Instead of making the Z shaped clamps, you could have purchased longer bolts for the clamps. 2. Instead of jogging the router around the piece to establish the start and end points of all the mortises, you could have measured them yourself, directly off the table. You know where the home position is, so using that, place a carpenter's square on the table at that location then take measurements off of it. And as you said, you don't have to be very accurate, so this method should be just fine. Again, I really like what you've done here. Good going and thanks for sharing it with us.