Holley Throttle Return Spring Kit

[@lyrebirdfurniture522]

Thanks for the video just installed this on my ride.

[@michaeld4879]

Great video, you weren't joking about this, my spacer for the carb stud is too tight... It also doesn't seem to want to sit very flat.

[@jordanmcmillan2762]

instead of bending the tab, could you just attach the bracket on the backside?

[@lanceconley3466]

Nice wheelie

[@RK-iw8jz]

Thanks for the video, sure helps seeing it!

[@klaus8910]

Would this work with an Autolite 4100?

[@anthonymolares4427]

Will this work on a 1995 dodge truck v10 L8 gas engine??

[@timsimons8946]

What about throttle cable? They want that is the same hole

[@ClassicSilveradoTrucks]

Would this bracket work with Edelbrock carbs if the bracket was modified some?

[@stratosjeff7007]

ive went through 3 of them, they all cracked in the same place

[@Mobigga]

Love the video. the orig carb bolt isnt long enough for that shim. what do you recommend to use? just a regular bolt?

[@CoolStuffGuysLike]

Thanks! I'd get a longer bolt or a stud to use in the place of it. Should be a 5/16-18 thread. Don't go too much longer though. Don't want to bottom out in the hole.

[@Mobigga]

@@CoolStuffGuysLike Thanks for the info! worked like a charm!

[@Fredsgarage]

Mine was the Moroso kit. And Yes the instructions don’t help at all. I put it on wrong with one spring. Thanks to your video I’ll redo.

[@thenijhelshow9304]

Great video but I couldn't help me cause edelbrock is set up completely different 🥴