How to make WORKING LED ground signals !
HTML-код
- Опубликовано: 15 сен 2024
- In this video i show how to build and construct your very own ground signals without breaking the bank !!
__________
Sponsor -: Rocketrailways.co.uk
Audio -: “Pure Cold - The Ritual”
soundcloud.app...
__________
LINKS
SIGNAL SHELL/FRAME
/ rustyrailsmodelling (View Shop Tab)
www.ebay.co.uk...
BATTERY HOLDER
www.ebay.co.uk...
SWITCH
www.ebay.co.uk...
LED 0603
www.ebay.co.uk...
LED 0402 (Micro)
www.ebay.co.uk...
___________________
/ itspurecold
/ rustyrailsmodelling
Great little signals to make. Using the Clear Resin UV Cure glue makes fitting the LEDs so much simpler.
Fantastic idea !! Thanks bro
Smart and this design of signal is fine for BR steam or later era. Glad you mentioned light bleed, if you are new to lighting models you must take it into consideration from the start of your project. As a matter of interest I have heard a railwayman refer to this type of signal as cats eyes. Good production, like the look of your den!
Quick point, if you're using 2x1.5v batteries to run the signal, you won't need a resister. If you're using a 12v DC feed, then a 1k resister will be sufficient.
Yeah the 1K resistor is for when I was using a to colour LED… If you look at the schematic you’ll see I wrote that in the notes :-) but thanks so much for notifying me 😊🙏🏽
Very informative. Thanks for sharing. Dave
Thanks for the kind words 😊
Nice one could you make RETB Signals?
I can look in to it for sure
@RustyRailsModelling OK thanks I'm planning on building a layout and i want it to have RETB signals
Now I need a reason to incorporate these signals so I can order them 😁
Great tutorial! What was the “big camera” you featured btw? Thanks!
Haha they’re great signals !
The big camera is a “Blackmagic pocket cinema camera 4K” (Bmpcc4k) 😊
I thought it was the BMPCC! I have used them as well and they are a ripper of a unit for video!
You must also be the first model railway RUclipsr to use one for their videos! 🤣
Are you planning a limit of shunt model? Just the two lower red lights, need a few 👀
I could do you a couple of custom hood moulds if that’s all that needs changing… It might take me a couple of days just because I have a few projects going on
@@RustyRailsModelling that would be amazing! I’m just sticking a order on ebay now, i’ll leave a note on there for you?
@@x47r_st just received:)
convert one. All an LOS board is, is a GPL signal with the top lens blanked.
Hi great work .... any chance of doing this in N gauge ??
I wish! It’s hard enough doing it In oo gauge.. I think it would be a bit too small and tricky to go smaller if I’m honest…
Hmm, sorry but the (now very) old Eckon version has the edge on you.
No light bleed and show the correct aspect and really easy to construct (for about £13).
Not a bad first attempt but needs work.
I'd reccomend you read up on signalling practices and operation.
The signals shells are a pack of 6 and the Leds really don’t cost much if you don’t choose Uk seller..
@@RustyRailsModelling ok.
Bit of a wait getting some bits from China but I suppose if there is no rush to build them it's not a problem.