so will these eventually stop transfering the patterns over time, especially with the glitter I just figured it takes some of it off each use but I could be wrong
Its a pattern that reflects light to make what you see so its not transferring anything its just the plastic melts into the pattern. same as the bumpy look with the textured PEI sheets, Just much smaller. should last until something damages that pattern.
@@shanold7681 oh thats cool thanks for the information I was thinking of printing some of those 3d art panels since they cost about 100 bucks for 12 here and with the diamond pattern I would just make flat panels with some texture to make it pop
It does start to fade/wear out over time if you always print in the same spot. It's recommended to move your prints around to avoid wearing it out. Also, it's best to let it cool down before you remove print, it could damage the surface if you yank the print off.
Do you pick smooth plate in the slicer?
Yes, select smooth PEI/ High temp
so will these eventually stop transfering the patterns over time, especially with the glitter I just figured it takes some of it off each use but I could be wrong
I think they probably will, but not because glitter. I believe these are micro-etched plastics which cause light refractions
Its a pattern that reflects light to make what you see so its not transferring anything its just the plastic melts into the pattern. same as the bumpy look with the textured PEI sheets, Just much smaller. should last until something damages that pattern.
@@shanold7681 oh thats cool thanks for the information I was thinking of printing some of those 3d art panels since they cost about 100 bucks for 12 here and with the diamond pattern I would just make flat panels with some texture to make it pop
It does start to fade/wear out over time if you always print in the same spot. It's recommended to move your prints around to avoid wearing it out. Also, it's best to let it cool down before you remove print, it could damage the surface if you yank the print off.
@@CarlexDIY gotcha yeah that makes sense and its easy enough to move the print around
Is that a 2nd AMS lite installed?!
I wish. No, it's only 1 AMS lite and the A1 and mini can only work with 1 Lite. Unlike the X1or P1 that can connect multi AMS units.
@@CarlexDIY
Hi.
Would you do using the H1H Light Beam one?
Thanks.
Those plates look nice but I don't currently own any H1H Light Beam plates to try it out. I will, if and when I do get it.
@@CarlexDIY Great. It would be awesome. Thanks.