I've got a Transit now and I don't know why they design it like this. I had a VW T5 before and I could do discs and pads on the front in under an hour. Really easy to do.
Iv a 22 plate tourneo custom.... From the day i picked it up new.. Untill now, almost 2 years later, the front drivers side brake as squealed.... After 3 garage visits, and rac having checked it, it is still squeaking when I brake, just before coming to a standstill it starts..... It's at another garage tomorrow... All the other brakes are fine........ The engine bay is absolutely soaking on the drivers side, pointed this out to garages, don't know if it's connected..... 48k motor and I hate it....!
Most likely will be connected to the leak in the engine bay, especially if it's only that brake doing it. Even after fixing the leak it may take changing the pads and a good clean of the disk to get rid of it
I’ve just done discs & pads on 2020 model and now have the abs, tc light on also goes into limp mode after a few minutes of driving. Any ideas appreciated! Tia
Is it possible that you snagged on the abs sensor wire as you were changing them? Have you had a computer plugged in to read what the code actually is?
Hi, Ive just realised that the end of the video has been cut out. It should be tightened to 250Nm, turn rotate the hub a few times to settle the bearing and make sure it feels okay. Then final torque is to 420Nm
Very good video. Thanks for showing the options without a high torque impact wrench, it’s one of the few tools I don’t own and can’t justify buying.
I'm glad it helped you out!
I've got a Transit now and I don't know why they design it like this. I had a VW T5 before and I could do discs and pads on the front in under an hour. Really easy to do.
@@thephoenixscotland I think the ford design is more dated but also heavier duty. It is not too bad to do providing you have the big torque wrench
Great vid . Is this the same on the face lift 2019 model
Hi, yes I believe so 👍
Iv a 22 plate tourneo custom.... From the day i
picked it up new.. Untill now, almost 2 years later, the front drivers side brake as squealed.... After 3 garage visits, and rac having checked it, it is still squeaking when I brake, just before coming to a standstill it starts..... It's at another garage tomorrow... All the other brakes are fine........ The engine bay is absolutely soaking on the drivers side, pointed this out to garages, don't know if it's connected..... 48k motor and I hate it....!
Most likely will be connected to the leak in the engine bay, especially if it's only that brake doing it. Even after fixing the leak it may take changing the pads and a good clean of the disk to get rid of it
I’ve just done discs & pads on 2020 model and now have the abs, tc light on also goes into limp mode after a few minutes of driving. Any ideas appreciated! Tia
Is it possible that you snagged on the abs sensor wire as you were changing them? Have you had a computer plugged in to read what the code actually is?
What is the torque for the centre 36mm nut qhen tightenting
Hi, Ive just realised that the end of the video has been cut out.
It should be tightened to 250Nm, turn rotate the hub a few times to settle the bearing and make sure it feels okay. Then final torque is to 420Nm