Align it like the video here. If it's not Align to the mark, connect it to the harness then turn the AC on till it turns to the mark. Once it's lined up turn off the vehicle. Then install it. Hope it helps.
@@Coalcoman925 just subscribed, thanks for replying now another question . Do you have to calibrate the bottom one a certain way like the one you changed in the video or is it just a simple change & put the new one in
You only turn the key to set it to position. When it's on the mark turn it off and install it. Don't leave the car on. Only to put it in position. Then turn it of when it reaches the mark. Subscribe. Any questions let me know if i can help. Thanks
Thank you bro!! have not seen a video that tells you this, I was struggling to get it back in earlier and finally found this video!
Glad it was helpful
the best example of setting the position if its not in place!!
Thank you so much for this video, I wish I had seen it earlier! 😆
You're welcome please subscribe
Thank you!
Anytime. Please subscribe 🙏
Hey man when you are putting the actuator in what mode do you have it set to off or defrost?
Align it like the video here. If it's not Align to the mark, connect it to the harness then turn the AC on till it turns to the mark. Once it's lined up turn off the vehicle. Then install it. Hope it helps.
To defrost
What part number is the one at the bottom that controls the hot ? or which one is that one called ? Thanks
604-231
5F9Z19E616EA
Please subscribe to my channel
@@Coalcoman925 just subscribed, thanks for replying now another question . Do you have to calibrate the bottom one a certain way like the one you changed in the video or is it just a simple change & put the new one in
Yes. Do the same as in the video. Unless it's right on the mark already.
Which control the temperature. I was told the temperature blend door actuator but when I change my climate to heat it stays cold
That would be the upper actuator. That was the one i replaced.
Whenever I turn the car on it starts to move out of the position without me even touching the controls
You only turn the key to set it to position. When it's on the mark turn it off and install it. Don't leave the car on. Only to put it in position. Then turn it of when it reaches the mark. Subscribe. Any questions let me know if i can help. Thanks
When you install it it supposed to go in place and it won't move anymore. Make sure where it sits is not damaged