Great video great instructions. The fuse part is the most important because when replacing this actuator you can replace it but it doesn't know the positions of fully open and closed and in between so it's crucial that it's re calibrated with this technic, again great video thank you for the information. 🤘🏻
Hello my friend.. Please help me determine the reason why the air in all ventilation openings does not convert from cold to hot air... Type of car: Acadia 2008
It's leaving it in a setting where it only blinks and goes back off when trying to use the ac button. But you can adjust the strength and it'll change from hot to Luke warm. Just won't switch modes so it's not letting me turn the AC on
Question man I turned my heater on this morning it’s hot on driver side but freezing cold on passenger side ? Do yuno which actuator I need to replace ? Is it on my driver side or passenger side ?
Great instructions for blend door actuator replacement. Pulling the fuse to re-learn the new actuator was good advice.
Thanks, just did mine. Your video was the online one I found that had a repair on the drivers side. 🙏🏽
Cool! Glad it worked out for you!
Great video great instructions. The fuse part is the most important because when replacing this actuator you can replace it but it doesn't know the positions of fully open and closed and in between so it's crucial that it's re calibrated with this technic, again great video thank you for the information. 🤘🏻
Great information, but I need to get into the passenger side one. Do you have a video of that, what panel do i take off first!?
No information on that yet.
Hello my friend.. Please help me determine the reason why the air in all ventilation openings does not convert from cold to hot air... Type of car: Acadia 2008
When doing this does the ac need to be turned off
Do you know if this part fixes the feature of recirculating the cabin air or is it a different part?
Different part I do believe.
Will this work for the driver side blowing hot air instead of cold also?
Don't think so.
Which actuator would be the one to cause the vent modes to stay stuck on the same setting half on feet half through the dashboard vents
It's leaving it in a setting where it only blinks and goes back off when trying to use the ac button. But you can adjust the strength and it'll change from hot to Luke warm. Just won't switch modes so it's not letting me turn the AC on
It's either a blend door or mode door actuator.
Question man I turned my heater on this morning it’s hot on driver side but freezing cold on passenger side ? Do yuno which actuator I need to replace ? Is it on my driver side or passenger side ?
The passenger side should be your culprit.
@@MelvinZoopers okay thanks and another question are all 3 actuators the same like if I was order the same 3 actuators to replace them all ?
@@jbandzz2389 Good question. I would like to say yes but am not positive.
Was the actuator on your passenger side?
My AC blows cold on Drivers side NOT COLD on Passenger side. Would that be caused by this valve?
If you have separate driver/passenger controls then I would definitely look into the actuator.
Will this work on a 2018 and newer as well?
I can't say for sure, but I would say yes.
Heres a tip, only put the 2 easiest screws back and itll be just fine. No need to overwork urself trying to get all 3 in.
I will remember that.
How about cold air in the back and none in the front? Actuator??
I would say yes.
Cat's paw😂
🐈
Question : I have a 2011 GMC Acadia and my rear heat works fine but my front heat isn’t hot. (Still blows) would this fix my problem also?
It's two on the passenger side. Replacing one of those will fix that issue.
Where is the driver side actuator for a 2018 GMC Acadia?