Great tutorial but Im finding that my pins are too tight when I print these. My printer has been calibrated but still can't connect my parts. I wish I could adjust the hole a little larger but both dimensions are based off of the same sketch so how would you go about fixing this?
One way....Create a sketch on the surface of the holes...create circle say 0.2mm bigger than the pins and extrude cut. Adjust the dimension if needed. 👍
Thank you so much I saved your video on my favorites for future questions.
Glad it was helpful!
Best onshape tutorial on youtube ❤️
Wow, thank you!
Hi!This is really helpful!!
Fantastic, thanks for this
No worries!
Great tutorial but Im finding that my pins are too tight when I print these. My printer has been calibrated but still can't connect my parts. I wish I could adjust the hole a little larger but both dimensions are based off of the same sketch so how would you go about fixing this?
One way....Create a sketch on the surface of the holes...create circle say 0.2mm bigger than the pins and extrude cut. Adjust the dimension if needed. 👍