Around 6:10 what do you mean about cutting it 60 degrees but the mark your cutting isn't a 45 but you said your cutting it at a 45 anyway? That doesnt make sense
You set the bevel to your circular, saw to a 45. However, before circular saws were used, rafters were hand cut. So you would have to lay out that angle. The angle in plan view, looking down on the rafter is not a true 45 because it's a compound angle.
Around 6:10 what do you mean about cutting it 60 degrees but the mark your cutting isn't a 45 but you said your cutting it at a 45 anyway? That doesnt make sense
You set the bevel to your circular, saw to a 45. However, before circular saws were used, rafters were hand cut. So you would have to lay out that angle. The angle in plan view, looking down on the rafter is not a true 45 because it's a compound angle.
Far to confusing compared to other top roofing vudeos on this channel