How to replace the water pump on 2006 Yamaha 90 hp outboard motor.

[@mauionion2]

thanks for including key removal and gasket replacement.

[@billybarnett8942]

What did you see wrong with the impeller housing ? Where did the big round o ring go ? Thanks

[@factcamp813]

I'm pretty sure it goes underneath The lower portion of the Impeller housing. Wish you would have said that. However it's not needed for just doing the upper replacement

[@jimhughes1070]

That was a pretty professional video.... And it was awesome! 🤳🙏🏋️🇺🇸

[@Garpeinv]

Thank you so much for sharing this.

[@GPDIY]

Any time!

[@MrGreatnessHimself]

Great video

[@carlosmedeiros3854]

You were trying to fit the impeller backwards. the slot only goes one way, it's foolproof

[@yunierperez8987]

At 9:49 where you find this seal? My kit didnt bring them

[@markdimaio8396]

How do you remove the old water pump base? Mine is corroded and needs replacing. What the trick?

[@itsdavidkay]

Please comment back if you ever find out how to take it off. I just cracked mine trying to take it off. Thanks!

[@markdimaio8396]

@@itsdavidkay I simply pryed it up with screw driver

[@bashaz8559]

Was your water stream weak or absent?
Did the motor overheat?

[@GPDIY]

it was very weak.

[@spindlesworkshop9744]

Good info

[@GPDIY]

Thank you so much for your support and comment my friend.

[@loganhildebrand4924]

Where did you order your kit?

[@GPDIY]

I bought it on a local store.

[@jandelahoussaye9834]

Why didn’t you put any green gaskets

[@GPDIY]

If you look closer, the gaskets on this set are gray, and they are installed.
Thank you for watching.

[@patrickkelly1421]

@@GPDIY I noticed same thing in my kit. There is a 3rd gasket. No idea where it goes and I seen in the layout your kit. Is it extra?

[@kennethashley2073]

There was another layer that came apart, thats wherr the extra gaskets go I suppose.

[@kennethashley2073]

Im skipping that step also, I dont see it necessary it should still seal if the seat does move during dis assemble