Nice I just updated my gantry to the new style , so for example if u cutting mdf or maple what is your feed rate ? And what is your depth per pass? What about aluminum what is your feedrate and what is your depth per pass ? Thank y sir
Damn looking good! It's been a while since Ive tuned in. The new gantry has my eye, mine is the original and there is quite a bit of slop, not sure if it is because I didnt get all the nuts and bolts tightened correctly or due to warping of the gantry pieces when I printed it on my A8...maybe even a little of both. I have an Ender 3 now and its been sitting idle, I think I found me a new project. :) Every time I check your stuff out, I get re-inspired. Thanks for that and keep up the good work!
Hey, just a quick question. Im building a Primo at the moment and im a little confused about the endstops. In the V1 Dual Endstop documentation it says using the M666 command it offsets the X1/Y1 endstops/motors, but in the Firmware it says the adjustment is made too X2/Y2 endstops/motors. I looked on the V1 forums but the thread i found is unclear about it too, since you have it working i would appreciate it if you could let me know which one it actually adjusts. thanks ! Also keep up the videos, your the main reason im building a MPCNC Primo :)
Keep the info rolling! Thanks Brian, I'm looking to build one next year. :D
Is the rambo board better than a ramps board for this application?
@@ProjectsbyBrian gotchya thanks!
Nice I just updated my gantry to the new style , so for example if u cutting mdf or maple what is your feed rate ? And what is your depth per pass?
What about aluminum what is your feedrate and what is your depth per pass ?
Thank y sir
Damn looking good! It's been a while since Ive tuned in. The new gantry has my eye, mine is the original and there is quite a bit of slop, not sure if it is because I didnt get all the nuts and bolts tightened correctly or due to warping of the gantry pieces when I printed it on my A8...maybe even a little of both. I have an Ender 3 now and its been sitting idle, I think I found me a new project. :) Every time I check your stuff out, I get re-inspired. Thanks for that and keep up the good work!
Hey, just a quick question. Im building a Primo at the moment and im a little confused about the endstops.
In the V1 Dual Endstop documentation it says using the M666 command it offsets the X1/Y1 endstops/motors, but in the Firmware it says the adjustment is made too X2/Y2 endstops/motors.
I looked on the V1 forums but the thread i found is unclear about it too, since you have it working i would appreciate it if you could let me know which one it actually adjusts. thanks !
Also keep up the videos, your the main reason im building a MPCNC Primo :)
@@ProjectsbyBrian it does thnx
What size is your working area? Nice job!
The mpcnc doc revenge 😂