I have soldered u/c wires over many years, so maybe these tips may help? Bind the legs with 15amp fusewire. Always hold the iron (mine's either 60w or 90w) touching the bottom of the joint (as heat rises) and feed in the solder from the top and sides...the bottom takes care of itself! Use either acid cored solder or Bakers Fluid to flux the joints. Use cellulose thinners to clear away the flux residue from the wires. I hope these tips help you as much as they've helped me!
Great job.
Hi Mark, your vids were recommended to me by Cliff Harvey. This is a superb video. Thank you!
Awesome, thank you!
I'm glad I'm not the only one with attic planes.
😂
Nicely done Mark 👍🏻
Thanks 👍 looking forward to that Friday feeling
Hi Mark, my father has an old soldering iron I'll use next time. Nice film as always 🙂
Thanks
I have soldered u/c wires over many years, so maybe these tips may help?
Bind the legs with 15amp fusewire.
Always hold the iron (mine's either 60w or 90w) touching the bottom of the joint (as heat rises) and feed in the solder from the top and sides...the bottom takes care of itself!
Use either acid cored solder or Bakers Fluid to flux the joints.
Use cellulose thinners to clear away the flux residue from the wires.
I hope these tips help you as much as they've helped me!
Certainly are thanks for the tip regarding heating from the bottom especially.
Always better with the iron under the work piece I find😊
Good point
Soldering iron last seen at the marconi factory @ 1932!
😂
I use a micro torch for this type of soldering.
Should work well just watch the heat 🔥
Oh it works. Very quickly! LOL!