Filter design and debugging (LC cavity microstrip waveguide bandpass, low-pass, high pass) duplexer design 10 years of experience in HFSS simulation design and engineering, with a design frequency of terahertz. All designs are based on practice and guided by theory. Remote after-sales service is available, and long-term cooperation can provide on-site service!
Hai sir we are doing final project on rectangular microstrip low pass filter can you explain why we use only this measurements, why not other there is any reason for this please explain sir
Please don't use stepped impedance with structures that are far better analysed as stubs. This is where the errors have occurred. Stepped impedance analysis is for smaller width variations.
Filter design and debugging (LC cavity microstrip waveguide bandpass, low-pass, high pass) duplexer design
10 years of experience in HFSS simulation design and engineering, with a design frequency of terahertz. All designs are based on practice and guided by theory. Remote after-sales service is available, and long-term cooperation can provide on-site service!
Sir how can i fabricate my fhfss design.
Can you please guide me ?
@@Sulaiman7641-d3t I mainly produce filters. If you have filter or simulation design requirements, you can contact me.
What is the insertion loss? Is it considered in this project
Thanks bro, keep posting ..
Sir, how to fabricate antenan designed in hfss. Is there any online fabriaction facility. please i want you to tell me
Thank you very much
friend how did it come to that value of 6.18mm for the 50 ohm line?, does some conersão, what value of Elec. Length you used?
Sir can you give an example of how we can realise a BPF in HFSS software.
Please sir , that will be very much helpful for my project work.
Did u do
You are looking 3db value for cutoff frequency but i think we should look for 6db value because you plotted s21 parameter not the power ratio.
I am looking for the insertion loss of 3 dB which is related to 20log(S21) and 10log(power ratio), eventually both are same in dB. 😁
@@RFDesignbasics I want to call you how can I do that
BEST VID
Hai sir we are doing final project on rectangular microstrip low pass filter can you explain why we use only this measurements, why not other there is any reason for this please explain sir
Is there any specific reason behind taking the width of 50ohm line as 3mm? can u Please explain
Using this calculator www.emtalk.com/mscalc.php
@@RFDesignbasics Thank you Sir..
I am looking for filter design for band pass and dual pass band in cst studio suite 2019 can u please post
Can You upload videos on band pass filters Sir..
Please don't use stepped impedance with structures that are far better analysed as stubs. This is where the errors have occurred. Stepped impedance analysis is for smaller width variations.
♥️♥️♥️😇