How to view and decode UART or Serial Data on an Oscilloscope | Rigol Ds series DSO

In this video I will show you how you can decode UART/Serial data on an Oscilloscope .
#electronic #oscilloscope #uart #code #engineering #decode #arduino #dso

[@Khujandiho]

very good. that means we can read any code from any devices.

[@VictoriaBentell]

Ooo that's a nice feature. And here I've been printing out ASCII-to-binary charts. Thanks for sharing!

[@EngineerAnandu]

Good.

[@JayJay-ki4mi]

Very useful. Btw, always connect the ground. You're introducing the scope into the circuit so you should still ground it. My professor said always ground unless you have a reason not to.

[@alibaspinarele]

good explanation 👏

[@aaryabrahmbhatt3581]

Can u pls make more vedios for the codings?

[@aolremfor2]

Why is your Tx set up is for channel 3 but you are using channel 1 to measure.

[@jitulex]

its because i was not even looking at the tx pin, i was looking at only rx pin from which the arduino was transmitting the signal to the oscilloscope, and the rx was setup for channel 1